Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Read all instructions before using this heater. 2. Avoid obstructing airflow openings: Clean dust from grille and side openings periodically. If blocked in any manner, the overheat protector will automatically shut the heater off. 3. Do not operate heater when no one is present. 4. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet from the front of the heater and keep them away from the sides and rear. 5. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended. 6. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. 7. Always unplug heater when not in use. 8. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. 9. Do not use outdoors. 10. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container. 11. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 12. To disconnect heater, turn controls to off, then remove plug from outlet. 13. Do not insert or allow foreign objects to enter any ventilation, exhaust opening as this may cause an electric shock, fire, or damage to the heater. 14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 15. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored. 16. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. 17. Disconnect cord before cleaning or servicing. 18. Store in safe location where heater cannot fall or be damaged. 19. Avoid the use of an extension cord. The extension cord may overheat and cause a risk of fire. However, if you must use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. 20. Do not place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater. operating instructions 1. Place heater on any firm surface - tabletop, counter, desk, shelf or floor. Avoid soft or combustible materials such as carpet. 2. Plug cord into any 120V, 60Hz AC wall outlet. 3. Turn upper knob to desired setting: fan only, low heat (1200W), or high heat (1500W). 4. Use "High" setting for fast warm-up. 5. Turn lower knob to set thermostat at desired warmth. Adjust setting so heater shuts off just as room reaches desired warmth. 6. Once room is warmed up, you will save electricity and maintain more even heat by moving upper knob to "Low" setting. "TIP-OVER" SWITCH This heater has a built-in switch that automatically shuts off the heater if it is tipped onto its front or back. OVERHEAT THERMOSTAT This heater has a built-in thermostat that shuts off the heater (and "power" light) and energizes the "caution" light, if the grille becomes blocked and/or any overheating condition occurs. To reset: Turn heater off and disconnect the power cord. Remove the cause of the overheating and let heater cool down. Then reconnect the heater power cord and select desired setting. When the heater has cooled down sufficiently, the thermostat will reset the unit. maintenance WARNING: Always unplug the cord before moving or servicing. Do not immerse heater in water. CLEANING: Clean the heater grille with the brush attachment of your vacuum cleaner, removing lint and dirt from the inside of the heater. Clean the body of the heater with a dry, soft cloth. CAUTION: Do not use water, wax, polish or any chemical solutions such as gasoline, benzene, thinner, harsh cleaners, etc., as they will damage the heater. NEVER use alcohol or solvents. DO NOT ATTEMPT TO TAKE APART THE HEATER. STORAGE: Store the heater, with these instructions, in the original carton - in a cool, dry place. warranty BROAN ONE YEAR LIMITED WARRANTY Broan warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPO...