Stimmen - 2, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
For current details about model and specification availability in your country, please visit our local website listed on the back cover or contact your local Fisher & Paykel dealer. Safety and warnings Important! Please read the entire set of instructions before installing the island canopy. This island canopy is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the island canopy. There must be adequate ventilation of the room when the island canopy is used at the same time as appliances burning gas or other fuels. (A partial vacuum in the room could result in too high a concentration of gas in the air). You must read the details concerning the method and frequency of cleaning. There is a fire risk if cleaning is not carried out in accordance with the instructions. Do not flambe under the island canopy. Exhaust air must not be discharged into an existing flue that is used for exhausting fumes from appliances burning gas or other fuels. The minimum distance between the cooktop surface and the filters of the island canopy shall be 600 mm, or 650 mm if installed over a gas cooktop. Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is fulfilled. If the supply cord of this equipment is damaged it must only be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. Always switch the power off prior to installation, servicing or cleaning the island canopy. Never use the island canopy without the filters in place. Stainless steel is very easily damaged during installation if abraded or knocked by tools. It is recommended to protect the top of the canopy with cardboard or polystyrene during the installation to minimise the risk of damage occurring. A power outlet should be within 750 mm of the motor assembly and can be either on the wall, behind the chimney or in the ceiling. To comply with electrical safety regulations, this canopy must be plugged into a socket near the appliance. The socket must be accessible, or have an accessible isolating switch, to enable the end user to isolate the canopy from the power for the purpose of internal cleaning or maintenance. Ducting accessories are not supplied. All ducting must comply with local requirements and building codes. WARNING! Electrical Shock Hazard All electrical work must be done in accordance with local and/or national electrical codes as applicable. For safety, this product must be earthed. If you are unfamiliar with methods of installing electrical wiring, employ the services of a qualified electrician. Turn off power at service entrance before installing wiring or servicing this product. WARNING! Weight Hazard The island canopy is heavy. Please ensure adequate care is taken when installing the island canopy to prevent personal injury. The island canopy must be installed onto a solid wall, stud, beam or truss. Weight of the product is 43.2 kg. Installation instructions Thank you for purchasing a quality Fisher & Paykel island canopy. Each island canopy is tested and approved before it leaves the factory, ensuring our high standard of quality control is met. Contents of packaging 1 x island canopy 2 x chimney pieces 8 x angle brackets 1 x installation instructions 4 x aluminium mesh filters 4 x 12 x 40 mm screw 30 x 6 x .” self tapping screw (2 spare) Typical equipment required: Electric drill Screwdriver Duct tape Jig saw Ladder Ducting Tape measure Drill bits Spirit level Accessories Fig.1 Designer island canopy Accessory Part Number Chimney ext 3048 mm (10’) ceiling SS 89094 Chimney ext 3048 mm (10’) IR 89095 Recirculation kit RR1744 Replacement charcoal filter R104165 Light bulb R104467 Replacement aluminium filter R104660 Installation instructions Height of island canopy The island canopy is designed for 2440 mm high ceilings. The chimney is telescopic and is designed for hood installations between 600 to 750 mm above the cooking surface. Filter surface Ascertain the desired installation height of the island canopy. Any installation above 750 mm will compromise the extraction performance. Cooktop The air outlet from the motor requires 150 mm round ducting which requires a 160 mm (min) diameter hole in the ceiling. A = 600 min (electric cook top) A = 650 min (gas cook top) Fig.2 Positioning Ducting options Recirculation For recirculation, please purchase a recirculation kit (part no. RR1744). The recirculation kit is required to channel the air out through the side-vents at the top of the flue. Note: a ducting hole is not required to be cut in the ceiling if a recirculation kit is fitted. Ducting For ducted installation, it is recommended that you use 150 mm diameter, rigid or semi-rigid ducting. This will require a 160 mm (min) round hole in the ceiling, which the decorative chimney will cover. Care should be taken to align the canopy with the decorativ...
Dieses Handbuch ist für folgende Modelle:Ventilatoren - HI120DXB1 (394.9 kb)