Stimmen - 2, Durchschnittliche Bewertung: 3 ( )

Hersteller: GE Dateigröße: 84.59 kb Dateiname: b692586c-c48c-4bcf-be7e-25800fab7ea5.pdf Unterrichtssprache:

Position the fan so that the tabs rest flat against the joist or stud and secure with four nails (not provided) to ensure proper installation. 5/8" 3/8" 1/2" 1/4" Figure 3 SECTION 3 Existing Construction 1. Position housing against the joist or stud and trace an outline of the housing onto the ceiling/wall material (Figure 4). Set housing aside and cut opening, being careful not to cut or damage any electrical or other hidden utilities. Place housing next to the joist or stud and insure that it is flush with the finished ceiling. Secure with four nails (not provided) to ensure proper installation (Figure 3). Figure 4 SECTION 4 Ducting CAUTION: ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL BUILDING CODES. 1. Connect the ducting to the fan’s duct collar (Figure 5). Secure in place using tape or screw clamp. Always duct the fan to the outside through a wall or roof cap. Figure 5 NOTE: If damper detaches from unit, reattach by snapping the collar back onto the unit. It is designed to only fit one way. 210572116 Rev. B 5-06 2 of 4 SECTION 5 Wiring CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION. CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN. 1. Run wiring from an approved wall switch carrying the appropriate rating. One neutral (white), one ground (green or bare copper), and one hot (black lead connected to the switch). Secure the electrical wires to the housing with an approved electrical connector. Make sure you leave enough wiring in the box to make the connection to the fan’s receptacle. 2. From where you have access to inside the fan’s junction box, connect the White wire from the house to the White wire from the fan’s receptacle. Connect the Black wire from the wall switch to the Black wire from the fan’s receptacle. Connect the ground wire from the house to the Green wire from the fan’s receptacle (Figure 6). Use approved methods for all connections. Figure 6 Ground Hot (Black) Supplyfrom house White SECTION 6 Completing the Installation 1. Reinstall the fan’s venturi by holding it at approximately a 45 degree angle, hook the two tabs on the venturi into the slots on the housing and secure in place by tightening the venturi screw. Rotate the blower wheel by hand to ensure it spins freely. Now plug the fan motor into the receptacle (Figure 7). Figure 7 2.Install the grill by squeezing the two ends of the springs together and installing them up into the slots of the fan’s venturi. Push the grill up into position (Figure 8). Figure 8 3. Restore power and test your installation. SECTION 7 Use and Care CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT. 1. Cleaning the Grill: Remove grill and use a mild detergent, such as dishwashing liquid, and dry with a soft cloth. ...

Herunterladen

Geben Sie zwei Ziffern: