Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
When the hood is turned on, the air pressure of the exhaust fan automatically opens the flap blowing the inside air and cooking odors outside. Recirculation mode (recirculation installation kit available as an optional accessory) Air is drawn through the grease filters and an active charcoal filter. The filtered air is then recirculated back into the kitchen through a vent at the top of the hood’s chimney. Active charcoal filters may be purchased from your Miele dealer or Miele. Before using the hood in recirculation mode, ensure that the active charcoal filter is in place, see "Cleaning and care". Guide to the hood 8 Guide to the hood Vent connection Control panel Grease filter Expandable fume deflector Overhead cooktop light Active charcoal filter Optional accessory for recirculation mode Facia Panel Accepts a custom front panel with the DML 300 kit, optional accessory On/Off button Power level buttons Four fan speed selection Light button Operation Turning the fan on ^ Pull the deflector out. The hood will operate at power level "2". The On/Off indicator and the second "-/+" indicator will light. Selecting the power level Depending on how much the air needs to be filtered, there are four power levels available. ^ Use the "-/+" buttons to select the power level required. The indicators show which power level has been chosen. For normal cooking a low to medium level is usually sufficient. For frying or cooking food with a strong aroma use the highest level. Pull the deflector all the way out to ensure an optimal intake of cooking odors. Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this value. Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level 3 operates at 80% capacity Level 4 operates at 100% capacity There will also be a slight decrease in airflow for hoods operated in recirculation mode due to the active charcoal filter. Turning the fan off ^ Push the deflector back in. The next time the deflector is pulled out, the hood will operate on power level "2". or ^ Press the On/Off button to turn the fan off. The indicators go out. Operation Automatically switching back the Intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Turn the fan and the lights off. ^ Press and hold the "-/+" buttons for 10 secs. The first indicator of the fan power levels lights. ^ Press the following buttons one after another, – light, – the "-" button, and – the light button again. If the power level indicators flash the automatic switch back is not activated. ^ To activate the automatic switch back press the "+" button. The power level indicators "1" and "4" light. ^ To deactivate the automatic switch back press the "–" button. ^ To save the setting press the On/Off button. Turning the light on and off The light for illuminating the cooktop can be turned on or off independently of the fan. ^ Pull the deflector out to turn the light on. Push it in to turn it off. or ^ Press the light button. When the light is turned on the indicator next to the button illuminates. ^ Press the light button again. The indicator will go out. Cleaning and care Casing Before servicing or cleaning the hood, disconnect it from the power supply by "tripping" the circuit breaker or unplugging it. Make sure power is not restored to the appliance while maintenance or repair work is performed. Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. ^ Wipe dry using a soft cloth. Do not use too much water when cleaning the controls. Water could penetrate the electronics and cause damage. Stainless steel surfaces (excluding the controls) Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can be applied. Controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Grease filter The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). The grease filter should be cleaned every 3 - 4 weeks. A dirty filter is a fire hazard. ^ To remove hold and pull out the deflector and the grease filter together. ^ Pull the grease filter downwards and out. Support the grease filter so that it does not fall onto the cooktop. ^ Turn the hood off. Cleaning the filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. They could destroy the filter. ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. Use a hot ...
Dieses Handbuch ist für folgende Modelle:Ventilatoren - DA 3160 (1.48 mb)