Stimmen - 4, Durchschnittliche Bewertung: 3 ( )

Hersteller: Hotpoint Dateigröße: 1.15 mb Dateiname: Unterrichtssprache:

Fixing to the wall 1) Draw a line on the wall along the vertical axis of the hob. Mark the 2 holes (A) to be made in the wall respecting the measurements indicated in the figure below. 2) Drill the holes (8 mm o) and fit the 2 screw anchors (provided). 3) Fix the metal bracket (B) to the wall with 2 screws using the 2 holes drilled. Use the 2 triangles cut into the bracket to position it exactly along the vertical axis of the hood. 4) Then hook the hood onto the metal bracket.Adjust the horizontal position by moving the hood to the right or left as required to align it with the wall units. If the hood also needs to be adjusted in height, operate on the adjusting screws (C). 5) Once adjusted, finally fix the hood with a further 4 screws (D): Mark the 4 holes to be drilled on the wall, unhook the hood and drill the holes marked (8 mm diameter); then use the screw anchors and the screws provided for final fixing. 6) For the hoods in filtering version, fit the reducer (E). Securing the decorative flue 1) Assemble the support bracket of the decorative flue and adjust the width with the 2 screws (F). Then, using the screw anchors and the screws (G), secure it to the ceiling in such a way that it is in line with the hood. 2) For the filtering version, the air vent grilles (H) must be positioned at the top. For the ducting version, turn the upper flue upside down so that the air vent grilles are at the bottom. 2 3) Ducting version: d) Make the electrical connection of the hood by means of the power cable (refer to the paragraph a) Connect the air vent of the hood to the air vent “Electrical connection”). hole using a flexible hose of 15 cm diameter. e) Lower the lower flue resting it on the hood. Lock the flexible hose with hose clamps (hose f) Check if the charcoal filter (P) has been and clamps not provided). installed. If not yet installed, proceed by sliding b) Make the electrical connection of the hood by the 2 filter clips into their seats and turn the filter means of the power cable (refer to the paragraph upwards. “Electrical connection”). c) Fit the decorative flue resting it on the hood. Lift the upper flue up to the ceiling and secure it by means of the 2 screws (L). 4) Filtering version: a) Fit the baffle (M) to the upper flue using 4 flat- headed screws (N). Connect a flexible hose of 12.5 cm diameter to the baffle locking it with a hose clamp (hose and clamp ...

Herunterladen

Geben Sie zwei Ziffern: