Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
12 Mounting the cooker hood - Fig. 7 Position the template on the wall and mark the position, and drill the holes (2 x O 8 mm).Mount the two rawl plugs with the hooks (3) Hang the hood on the hooks and level it with the adjustment screws (4) Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x O 8 mm). Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it horizontally with the screws (8) and secure it with the screws (9) Mount the chimney holder (10) with the rawl plugs (12) and the screws (11). Be careful that it is centered over the hood and horizontally aligned. Fitting for ducting (S) Connect a tube between the hood air outlet and the wall or roof exhaust channel. Fix it with the tube clamps supplied. Fitting for recirculation (K) Mount the recirculation spigot with the two screws supplied. Mounting the chimney Place the chimney (15) and fix it to the top chimney holder with the two screws (16) supplied. Lower the bottom part of the chimney (17) and fasten it to the top of the hood with two screws, supplied. Note that the top part of the chimney can be mounted with the side grids up or down. For use as a recirculation hood it must be mounted with the grids upwards. (Fig. 6). Fig. 6 13 Fig. 7 12 12 14 Fig. 8 Power outlet Exhaust tube Electric hob 500 mm Gas hob 650 mm Charcoalandoil 700mm Wall bracket Electric hob 500 mm Gas hob 650 mm Charcoalandoil 700mm 15 AEG Hausgerate GmbH Postfach 1036 D-90327 Nurnberg © Copyright by AEG LI1H8C ...
Dieses Handbuch ist für folgende Modelle:Ventilatoren - 8160 D (349.84 kb)
Ventilatoren - 8160 D (349.84 kb)
Ventilatoren - 8160 D (349.84 kb)
Ventilatoren - 8160 D (349.84 kb)