Stimmen - 1, Durchschnittliche Bewertung: 3 ( )

Hersteller: DCS Dateigröße: 285.16 kb Dateiname: 687100en.pdf Unterrichtssprache:

• The upper part of the spice rack rear wall should be detachable (access for exhaust air hose or adjustment of furniture housing). Fig. 6a Fig. 6b Installing the fume extractor hood in the wall unit - extractor version (Filter version with carbon filter) • Apply the drilling template to the inside wall of the wall unit on the right and left sides, and mark out and predrill O 2 mm mounting holes as well as 2 x O 6 mm - 5 mm depth holes for the mounting claws (installation aids). • Unscrew the ventilation grill mounted on the appliance (1 screw), apply the exhaust air union prepared to the required exhaust air diameter, and twist it to the right to its fullest extent (so that it is retained). • Fully withdraw the vapour catcher of the hood. • Important: Detach and insert the grease filters only when the vapour catcher is fully withdrawn. Remove the grease filters. First remove the rear and then the front grease filter. • For 19 mm side walls, the spacer discs clipped in on the appliance body must be taken out. Mount the hood with 4 or 6 x O 4 mm screws. Fig. 7. Fig. 7 • Insert the hood in the furniture housing and engage both mounting claws (installation aids) on the right and left sides in the side wall of the wall unit and firmly hold the hood for further mounting. Then fix the hood with the 4 or 6 x O 4 mm screws supplied. • Refit the grease filters. Push-in the vapour catcher. • If the cupboard is deeper than 300 mm, cover the gap between the hood and the wall with a finishing strip (special accessory). To install it, proceed as follows: Measure the wall distance and apply the covenng strip over the necessary width (wall distance plus 5 to 8 mm), kinking the covering strip at the appropriate notches and tearing off the surplus material (removing the protective foil). Then fasten the strip to the bottom part of the hood with three clips (special accessories). Apply pressure. Fig. 8. Fig. 8 Fitting the carbon filter for filter version If the fume extractor hood is installed as a return air appliance (Filter version - air outlet above the wall unit), the carbon filter (special accessory) must be fitted before the grease filters are fitted. Installation sequence: 1. Insert the holding frame for the carbon filter in the shaft of the hood with the 2 lugs facing upwards and then clip into the lower holes. 2. Fix the holding frame on the lower part of the housing of the hood with the 2 screws supplied. Fig. 9. 3. Fit the carbon filter (see paragraph “Carbon filter”) 4. Refit the grease filters. Push-in the vapour catcher. Fig. 9 Removing the hood from the wall unit If, for technical reasons (extractor version/filter version conversion) the fume extractor hood has to be removed from the wall unit, proceed as follows: • Fully withdraw the vapour catcher and remove the grease filter. • Loosen the 4 or 6 mounting screws of the hood (wall unit mounting). • To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips screw-driver in the...

Herunterladen

Geben Sie zwei Ziffern: