Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Air King Dateigröße: 592.86 kb Dateiname: 2f60fba8-76b3-1644-fd9e-ad09a7c28bec.pdf Unterrichtssprache:

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. Charcoal Filters In the recirculation mode the charcoal filters absorb smells and unwanted odours. This charcoal filters cannot be washed or regenerated, and must be replaced when the F touch control starts to flash, or at least once every 4 months.The alarm is only triggered when the motor is on. Enabling/Disabling the alarm signal • In Recirculation Version Hoods,the Filter saturation Alarm must be enabled at the time of installation or later. • Switch off the lights and the motor. • Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off. • Restore the connection, pressing and holding T2. • Release the touch control, touch controls L, T2 and F will light up normally. • Within 3 seconds press the touch control F until the key itself flashes to confirm as follows: • 2 flashes – Charcoal odour Filter saturation Alarm ENABLED • 1 flash -Charcoal odour Filter saturation Alarm DISABLED To Remove/Replace the Charcoal Filters • First remove the metal grease filters. • Remove the saturated activated charcoal filter by releasing the fixing hooks as illustrated. • Position the new charcoal filter in the position marked and while holding the filter replace the fixing hooks as illustrated Reset the alarm signal • Stop the motor. • Press the touch control F for at least 4 seconds, until the touch control T1 flashes. This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended. Changing the Halogen Spot Lamp • Unscrew the two screws to release the metal surround. • Remove the lamp from the holder by pulling the lamp downwards. • Replace the lamp with a new one of the same type, making sure that you insert the two pins properly into the housings on the lamp holder. • Replace the Support, fixing it in place with the two screws removed as above. Replacement filters and light bulbs can be obtained from your local Service Force Centre. Something not Working If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force agent. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution The cooker hood will not start • Check the hood is connected to the electricity supply. • Make sure the switch is in the ‘ON’ position. The cooker hood is not working effectively • Check that the fan speed is set high enough for the task • Ensure the grease filter is clean. • Ensure the kitchen is adequately vented to allow the entry of fresh air. • If set up for recirculation, check that the charcoal filter is still effective. • If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation • The safety cut-out device has been tripped. • Tum off the hob and then wait for the device to reset. Repairs and After Sales Service In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact our extended warranty administrators by telephoning: 0870 01 07887 They will give you details for your local Service Force Centre. Before calling out an engineer, please ensure you have read the details under the heading “Something Not Working”. Your oven is covered by a 3 year parts and labour guarantee (see separate details given at point of sale). Please retain your purchase receipt safely for the service engineer to verify the purchase details. When you contact the Service Force Centre you will need to give the following details: 1. Your name, address and post code 2. Your telephone number 3. Clear and concise details of fault 4. The model and serial number of the appliance (found on the rating plate - see picture) 5. The purchase date. Please note that a valid purchase receipt is required for in-guarantee service calls. John Lewis Partnership 171 Victoria Street London SW1E 5NN 4360034...

Herunterladen

Geben Sie zwei Ziffern: