Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Smeg Dateigröße: 575.58 kb Dateiname: 914772406-GB.pdf Unterrichtssprache:

CONTENTS RECOMMENDATIONS AND SUGGESTIONS 10 CHARACTERISTICS 11 INSTALLATION 12 USE 14 MAINTENANCE 15 GB 9 GB 10 RECOMMENDATIONS AND SUGGESTIONS INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. • The minimum safety distance between the cooker top and the extractor hood is 650 mm. • Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. • For Class 1a appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible. • Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.). • If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. • Never use the hood for purposes other than for which it has ben designed. • Never leave high naked flames under the hood when it is in operation. • Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. • Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. • The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE • Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. • Clean and/or replace the Filters after the specified time period. • Clean the hood using a damp cloth and a neutral liquid detergent. 650mm.min. GB 11 L1 284 O119 200 8 174 CHARACTERISTICS Dimensions Hood Type 52 70 L1 522 702 Components Ref. Q.ty Product Components 1 1 Hood Body, complete with: Controls, Light, Filters Q.ty Documentation 1 Instruction Manual GB 12 Vf 13 259 L1 INSTALLATION Drilling the Support surface and Fitting the Hood Make a rectangular opening on the base of the hanging unit, leaving a minimum of 13 mm from the outer edges. Hood Type 52 70 L1 497 677 SNAP-ON FITTING For hoods with snap-on side supports only, set up for a support panel thickness of between 15 mm and 30 mm. • Insert the hood until the side supports snap into place. • Lock in position by tightening the screws Vf from underneath the hood. GB 13 112250 9 o 120 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe o 120 mm. • Fix the pipe in position using sufficient pipe clamps (not supplied). • Remove any activated charcoal filters. RECIRCULATION VERSION AIR OUTLET • Cut a hole o 120 mm in the wall unit over the hood. • Connect the hood body outlet to the top part of the wall unit using a rigid or flexible pipe o 120 mm, to be selected by the installer. • Fix the pipe in position using sufficient pipe clamps (not supplied). • Ensure that the activated charcoal filters have been inserted. ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap ...

Herunterladen

Geben Sie zwei Ziffern: