Stimmen - 6, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: KitchenAid Dateigröße: 297.39 kb Dateiname: b2386775-00d3-4a4a-b569-8a7231b5dd3f.pdf Unterrichtssprache:

30" (76.2 cm) and 36" (91.4 cm) Traditional Series Vented and Non-Vented Range Hoods IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector's use. Quick Reference Table of Contents: Pages 4 6 8 2 2 3 3 6 6 7 7 9 Before you start Electrical requirements Vent system requirements Product dimensions - Installation steps Wiring diagram - Use and Care Information Warranty - Requesting Assistance or Service Part No. 4329145 04-260500/8284977 Piece N° 4329145 04-260500/8284977 Before you start... Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”. These obey all safety messages. words mean: DANGER You can be killed or seriously injured if you don’t immediately follow 2 Proper installation is your responsibility: • Have a qualified technician install this range hood. • Comply with installation clearances specified on the model/serial rating plate. If installation is non-vented (recirculating), you must use Non-Vent (recirculating) Kit Part No. 4396273, available from your dealer. The kit fits all models. The model/serial rating plate is located inside the range hood. To access, remove the grease filters. Range hood location should be away from strong draft areas, such as windows, doors and strong heating vents. Grounded electrical connection is required. See “Electrical requirements.” Important: This hood must be a minimum of 24" (61 cm) above cooking surface. All openings in ceiling and wall where range hood will be installed must be sealed. Important: Observe all governing codes and ordinances. You can be killed or seriously injured if you don’t follow instructions. WARNING All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. instructions. Tools and materials needed for installation: • Phillips head screwdriver • drill • 1-1/2" (4.0 cm) drill bit • keyhole saw • sabre or jig saw • metal snips • tape (for template) • duct tape • pencil • UL- or CSA-listed 1/2" (12.5 mm) conduit connector (for range hood) • 1 wall or roof cap • power supply cable (if not previously installed) • metal vent system (if not previously installed) Parts supplied: • four 2-3/4" (7 cm) screws • four 2" (5.1 cm) screws • hood installation template WARNING — TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable Codes and Standards, including fire related construction. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimne...

Herunterladen

Geben Sie zwei Ziffern: