Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
To Set or Adjust Blower Speed . Vary the blower speed as needed for the food or the cooking method being used. For example: greasy or pungent foods require greater ventilation power than boiling pasta. Turn the button clockwise to adjust the speed. Intake The intake, when raised, captures and channels the cooking odors, steam and grease. The filters are located within the intake. UP/DOWN Button The UP/DOWN Button is located on the top right of the intake. Press the Button once to raise or lower the intake. It is not necessary to hold the Button. Blower The blower is the fan that draws the cooking odors out of the house. Blower Speed Control Switch The blower speed control switch is located on the right front of the intake. The intake must be raised in order to use the control switch. There are four blower speed settings: Off, Low, Medium, and High. Slide the switch to the desired setting. Filters The filters are located on the front of the intake. They condense and trap the grease in the air. Filter Release Levers The filter release levers are used to remove the filters. Pull out on the lever then pull up and out on the filter. .. Intake Top Cap .. UP/DOWN Button .. Blower Speed Control Switch The Thermador Universal Cook’n’Vent® takes the place of an overhead hood and can be conveniently hidden away (lowered) when not in use. .. Filters (behind front panel) .. Filter Release Lever .. Blower (not shown) There are five primary parts of the downdraft system: the intake, the UP/DOWN button, the blower, the blower speed control switch, the filter and the filter release lever. • 0 • 1 • 2 • 3 Raised Intake .. .. .. .. .. • 0 • 1 • 2 • 3 Snorkel Up/Down Pushing the Snorkel Up/Down moves the intake up or down. Pushing this button while snorkel is raising or lowering will stop motion. Pushing again will reverse motion. 0 Blower Off 1 Low Blower Speed 2 Medium Blower Speed 3 High Blower Speed Pressing the High, Medium, or Low Blower Speed buttons will turn on or change the ventilator speed to the corresponding button selected. 5 CARE AND CLEANING To Remove Filters 1. Pull out on lever. 2. Lift filter up and out. 3. Clean filters in the dishwasher or in warm, sudsy water. See Care and Cleaning Chart, next page, for further details. To Replace Filters 1. Place bottom of filter in grease trough. 2. Pull out on lever. 3. Press top of filter into place. 4. Release Lever. To Clean the Intake and Grease Troughs Intake must be in the raised position to clean. 1. Turn off the blower. 2. Remove filters. 3. Clean intake and grease troughs with general household degreaser spray or cleaner. 4. Rinse and dry. 5. Replace filters. . Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels. . Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks. . After cleaning, place all parts in their proper positions before using. The cleaners recommended below indicate a type and do not constitute an endorsement. Use all products according to packag...
Dieses Handbuch ist für folgende Modelle:Kochfelder - DHD3014UC/02 (2.01 mb)
Kochfelder - DHD3614UC/01 (2.01 mb)
Kochfelder - DHD3614UC/02 (2.01 mb)