Stimmen - 4, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
AUSTRALIAN GAS ASSOCIATION CERTIFIED Certifi cate Number: 7153 Model: VRTIKL-AU FREESTANDING STOVE • Do not store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other appliance. • What to do if you smell gas - Do not try to light any appliance. - Do not touch any electrical switch. Do not use any phone in your building. - Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. - If you cannot reach your gas supplier, call the fi re department. • Installation and service must be performed by a qualifi ed installer, service agency, or the gas supplier. WARNING: If the information in these instructions is not followed exactly, a fi re or explosion may result causing property damage, personal injury, or death. DO NOT DISCARD THIS MANUAL CAUTION • Leave this manual with party responsible for use and operation. DO NOT DISCARD WARNING • Important operating and maintenance instructions included. • Read, understand and follow these instructions for safe installation and operation. HOT! DO NOT TOUCH. SEVERE BURNS MAY RESULT. CLOTHING IGNITION MAY RESULT. • CAREFULLY SUPERVISE children in same room as appliance. • Alert children and adults to hazards of high temperatures. • Do NOT operate with protective barriers open or removed. • Keep clothing, furniture, draperies and other combustibles away. Glass and other surfaces are hot during operation and cool down. • Keep children away. PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING THIS APPLIANCE. Model: VRTIKL-AU is Australian Gas Association APPROVED FOR NATURAL GAS OR PROPANE AS A BALANCED FLUE HEATER. Refer to the appliance data plates for gas consumptions and pressures. Installation of this appliance should only be carried out by an authorized person in accordance with the manufacturers instructions. Appliance is to be installed in full compliance with the National Gas Installation Standard AS5601, all relevant codes and regulations laid down by the gas fitting authorities, municipal building regulations, electrical wiring regulations, and the requirements of the AGA Gas Installation Code must be observed. This appliance and its components are tested and safe when installed in accordance with this Installation Manual. Report to your dealer any parts damaged in shipment, specifically check glass condition. The gas logs and flue system components are in separate packages. Read all instructions before starting installation and follow these instructions carefully during installation to ensure maximum benefit and safety. Failure to follow them will void your warranty and may present a fi re hazard. The Heat & Glo warranty will be voided by, and Heat & Glo disclaims any responsibility for the following actions: • Installation of any damaged heater or flue system component • Modification of the heater or balanced flue system installation other than as instructed by Heat & Glo. • Improper positioning of the gas logs or the glass door • Installation and/or use of any component part not manufactured or approved by Heat & Glo, not withstanding any independent testing laboratory or other party approval of such component part or accessory. IMPORTANT: Read all instructions carefully before starting installation. Failure to follow these installation instructions may result in a possible fire hazard and will void the warranty. Save this manual for future reference. Heat & Glo, a brand of Hearth & Home Technologies, Inc. 20802 Kensington Blvd., Lakeville, MN 55044, USA Heat & Glo Quality Systems Copyright 2007 • Printed in U.S.A. registered by SGS ICS Heat & Glo • VRTIKL-AU • 2123-900 • 7/07 Table of Contents 1 Listing and Code Approvals A. Design and Installation Considerations . . . . . . . . . . . . . . . 4 B. Non-Combustible Materials Specification. . . . . . . . . . . . . . 4 C. Combustible Materials Specification . . . . . . . . . . . . . . . . . 4 D. Inspect Appliance and Components . . . . . . . . . . . . . . . . . . 4 2 Framing and Clearances A. Selecting Appliance Location . . . . . . . . . . . . . . . . . . . . . . . 5 B. Clearances to Combustibles . . . . . . . . . . . . . . . . . . . . . . . 5 C. Optional Stone Surround Installed . . . . . . . . . . . . . . . . . . . 6 3 Termination Locations A. Flue Termination Minimum Clearances . . . . . . . . . . . . . . . 7 4 Flue Information A. Flue Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 B. Use of Elbows . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 C. Measuring Standards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 D. Flue Diagrams . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 E. Horizontal Termination . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 F. Slim Line Heat Shield . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 G. Vertical Termination . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 H. Vertical Flue Restri...