Stimmen - 4, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
Whenever the touch control is switched off, the residual heat is shown by a static " H ". Avoid touching the hob surface over the cooking area. Please pay special attention to children. It is still possible to start cooking again; just set the required power level. " H " is turned OFF when the cooking zone temperature drops below a preset temperature. Booster Function Rear Cooking Zone Only This function allows the cooking zone to operate at the Booster maximum power (above the nominal power) for maximum 10 minutes; it could be used, for example, to rapidly heat up large amount of water. This function is available for the rear cooking zone only. To activate the Booster function, the touch control must be switched ON (see section “How to Turn the Touch Control ON and OFF”). With the zone at any power level ( 0...9 ), just touch the key until the rear zone display shows "P". At the end of the Booster program (10 minutes) the rear zone is automatically set to the power level " 9 ". With the zone at the Booster level: – if touching again the key -a beep sounds, the heat up program is cancelled and the power level set to " 9 "; – if touching the key -an error beep sounds but none change is performed; – if touching the key -a beep sounds, the heat up program is cancelled and the power level set to " 9 ". Induction Heaters Power Management The maximum power of the cooktop is limited to 3600 W. This means that the electronic interface automatically manages the power levels of the heaters in order to not exceed the maximum power limit (see also table on the previous page). – Both the zones can be used, at the same time, from power levels " 1 " to " 9 "; – With the front zone set to power level " 7 ", " 8 " or " 9 ", if setting the Booster program on the rear zone the power level of the front zone is automatically reduced to " 6 ". – With the Booster program set on the rear zone, if setting the power level " 7 ", " 8 " or " 9 " on the front zone the power level of the rear zone is automatically reduced to " 9 ". Safety Key-Lock to Protect Children This function locks the touch-control keys against unwanted activation. To activate the key-lock press the key ; the indicator light above the key symbol will light up. – Cooking zone/s operating (power level already set) - with the key-lock protection active it is only possible to switch off the cooktop. – Cooktop off -with the key-lock protection active it is not possible to use the cooktop. To use the cooktop deactivate this protection. To deactivate the key-lock protection just press the key ; the indicator light above the key symbol will go out. Program for Automatic Switching OFF of One Cooking Zone This function permits to set a timer from 1 to 99 minutes for automatic turning OFF of one cooking zone only. Note: It is not possible to set this program for both the cooking zones. With the touch control switched ON: – Press the timer keys or ; a beep sounds and the timer display shows " 00 ". The displays of the cooking zones show " " (timer). – Within 10 seconds, select the cooking zone to be programmed by using the cooking zone keys or ; a beep sounds and the led next to the heater display start blinking. – Set the disired power level by using the cooking zone keys or ; the led next to the heater display is stably lit (not blinking). – Within 10 seconds, set the timer by using the timer keys or to increase or reduce the value (when touching the keys, the led next to the heater display is blinking). If the selected time is " 00 ", the timer is switched off automatically after 10 seconds. – The countdown starts 10 seconds after the last selection. The time can be changed at any time by using the timer keys; the countdown stops and then the timer changes the stop time. OROR Now the program for automatic switching off is complete. At the end of the countdown the cooking zone will switch off automatically, an acoustic signal (beep) will sound (for one minute only), " 00 " will flash on the timer display and the led next to the heater display will blink. Press any button of the touch control to reset the timer. Note: The program for automatic switch off can be cancelled at any time by resetting the timer to " 00 "). OR 14 14 Operation Time Limit of Cooking Zones Each cooking zone is automatically switched OFF after a maximum preset time if no operation is performed. The maximum preset time limit depends on the set power level, as illustrated in this schedule. Each operation on the cooking hob by using the keys , will reset the maximum operation time at its initial value. Cooking Zone Operation Power Level Time Limit 10 hours 5 hours 5 hours 4 hours 3 hours 2 hours 2 hours 2 hours 1 hour P Booster (rear zone only) 10 minutes Error Code on the Display/s If an error message appears on the display/s (the display/s show/s " F " and another character alternating - e.g. " F " and " A ", " F " and " 0 ", .....) : 1. Disconnect the cooktop from the mains. 2. Reconnect the cooktop an...