Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Indesit Dateigröße: 3.35 mb Dateiname: Unterrichtssprache:

Do not use thin aluminum cooking utensils or allow aluminum foil to touch the ceramic cooktop under ANY circumstances. • Aluminum utensils -The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the ceramic cooktop. If allowed to boil dry, not only will the utensil be destroyed, but it may fuse to, break or mark the ceramic glass surface, permanently damaging the ceramic cooktop surface. Changing Oven Lights The oven lights automatically turn ON when the door is opened. The oven lights may also be manually operated by pressing the @ pad. The oven light bulbs are located at the rear of the oven and are covered with a glass shield held by a wire holder. The glass shields must be in place whenever the oven is in use. Be sure the range is unplugged and all parts are COOL before replacing oven light. Weara leather-faced glove for protection against possible broken glass. To replace the oven light bulb(s): 1. Turn electrical power off at the main source or unplug the range. Wire 2. Press wire holder to one side to release the glass shield. Holder 3. Replace bulb with a new 40 watt appliance bulb. 4. Replace glass shield over bulb and snap wire holder into place. 5. Turn power back on again at the main source (or plug the range back in). 6. The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Guide. 40 Before You Call • Solutions to Common Problems Before you call for service, review this list. It may save you time and expense. that are not the result of defective workmanship or materials in this appliance. The list includes common occurrences OCCURRENCE Range is not level. POSSIBLE CAUSE/SOLUTION Poor installation. Place oven rack in center of oven. leveling legs at base of range until the oven rack Place a level is level. on the oven rack. Adjust Be sure floor is level and is strong and stable enough to adequately support range. If floor is sagging or sloping, contact a carpenter to correct the situation. Kitchen square cabinet and have alignment sufficient may room make range appear for range clearance. unlevel. Be sure cabinets are Cannot move appliance must be accessible for easily. service, Appliance Cabinets appliance not square accessible. or are built in too tightly. Contact builder or installer to make Carpet interferes with range. Provide sufficient space so range can be lifted over carpet. Oven code control beeps and displays error (for example Fll). any F Electronic control and stop beeping. CLEAR and call has detected a fault Reprogram oven. 1-800-4-MY-HOME® condition. PressSTOP/CLEARtoclearthedisplay If fault recurs, record fault number. Press for assistance (See back cover). STOP/ _'_ Surface burners do not light. Surface Surface desired Control knob Control knob flame size. has not to LITE been completely turned until burner ignites and to LI...

Herunterladen

Geben Sie zwei Ziffern: