Stimmen - 4, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Indesit Dateigröße: 473.79 kb Dateiname: Unterrichtssprache:

caps, side panels, door DO NOT USE ABRASIVES. handles. Aluminium Hotplate side trims, hotplate Similar to paint cleaning above. Use a nylon brush to burner bodies, lid rear trim, remove any cleaning materials, water or dirt from the rear flue grille. hotplate burner bodies. Glass As for enamel cleaning. Polish with a clean dry cloth or kitchen roll. Chromium Plating Oven shelves, grill pan grid, Wipe with a cloth wrung out in warm soapy water. grill pan handle support A fine steel wool soap pad e.g. Brillo, Ajax, or a chrome or stainless steel cleaner may be used. Plastic Grill pan handle, control Wipe with a cloth wrung out in warm soapy water. knobs Stubborn stains can be removed with a cream cleaner. REPLACEMENT OF OVEN LIGHT BULB CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK Light bulbs are not covered by the manufacturer’s guarantee. A new 15W, 300°C rated SES bulb can be obtained from your cooker supplier or any major electrical retailer. 1. Remove the shelves from the oven. 2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely event of a lens fracture. 3. Unscrew bulb. 4. Fit new bulb and refit lens. Care and Cleaning Take particular care not to damage the inner surface of the door inner glass that is coated with a heat reflective layer. Do not use scouring pads, or abrasive powder, which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows. Stubborn stains can be removed by using a fine steel wool soap pad. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door. After cleaning, rinse and dry with a soft cloth. CLEANING THE DOORS SIDE OPENING DOORS Cleaning the door glass is the same as the drop down doors, except take care to support the weight of the inner glass when removing and refitting. DROP DOWN DOORS Remove the door inner glass as follows. 1. Open the door fully and unscrew the two screws securing the glass panel so that the securing brackets can be turned. There is no need to remove the screws completely. 2. Turn the brackets so that the glass can be and cleaned at the sink (Fig. 1.) Fig. 1. 3. The inside of the outer door glass can now be cleaned while still fitted to the cooker. NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION. Refit the door inner glass as follows. 1. NOTE: The inner door glass has a special reflective coating on one side. Replace the door inner glass so that the statement: “IMPORTANT THIS FACE TOWARDS THE OVEN” can be read from the inner side of the door. 2. Turn the two securing brackets back to their original position to retain the glass and tighten the screws (Fig. 2.) Fig. 2. Something Wrong with your Cooker? Before contacting your nearest Service Centre or Installer, check the problem guide below, there may be nothing wrong with your cooker. Burner ports Ignitor Burner ports Ignitor PROBLEM CHECK If all burners fail to ignite: Check that sparks appear at the burners; a clicking Oven burner Ignition does not work. noise should be heard. If not; Check that the electricity supply is turned on. If the electricity supply has failed, the hotplate, grill and top oven burners can be lit by a match. If only one burner fails to ignite: Check that the burner is dry and that spillage of food Grill burner or cleaning fluid remains are not affecting the ignitor or burner ports. Clean away any debris with a dry nylon brush such as an old toothbrush. If a wire wool pad has been used for cleaning around the burner ensure the ignitor is free from any stray strands. Any water on the burner should be dried with a cloth or kitchen towel. Hotplate burner. On the hotplate make sure that all the burner parts are correctly seated. Burner ports Ignitor Something Wrong with your Cooker? (KD643G only) Cannot set an “Auto Cook” programme or cannot get the timer to turn the oven on or off at the required times. Oven lamp does not work PROBLEM (KD643G only) Main oven does not work, but the grill, top oven and hotplate burners work. Slight odour or small amount of smoke when grill / oven used first time Oven cooks too fast or too slow (KD643G only) Timer Display shows "0:00" with "Auto" Flashing. Read the Timer instructions in this book carefully remembering that the Cook period is the length of time that the timer will switch the oven(s) on as part of an Auto Cooking Programme. The oven lamp is not covered by the guarantee. The part is easily changed (see the section on oven lamp replacement). A new lamp may be obtained from our Parts department see Key Contacts (back page). CHECK The timer may be set for an Auto Cooking Programme. Check the timer to see if “AUTO” is illuminated. If it is, follow the instructions given in the timer section of this book to cancel the Auto Cooking Programme. This is normal and should cease after a short period. Check that the gas mark and...

Herunterladen

Geben Sie zwei Ziffern: