Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Owners Manual for future reference. WARNING This appliance must be properly grounded. See “Power Supply”, page 8. ATTENTION Cet appareil doit etre correctement mis a la terre. Voir << Alimentation electrique >> a la page 8. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. See the Owners Manual for warranty information. For Monogram local service in your area, 1-800-444-1845. For Monogram service in Canada, 1-888-880-3030. For Monogram Parts and Accessories, call 1-800-626-2002. If you have a question concerning the installation of this product, call the GE Answer Center® Consumer Information Service at 800.626.2000, 24 hours a day, 7 days a week. If you received a damaged cooktop, you should immediately contact your dealer or builder. FOR YOUR SAFETY If you smell gas: 1. Open windows. 2. Don’t touch electrical switches. 3. Extinguish any open flame. 4. Immediately call your gas supplier. FOR YOUR SAFETY Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. • Installation of this cooktop must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1, latest edition. In Canada, installation must conform with the current Natural Gas Installation Code, CAN/CGAB149.1 or the current Propane Installation Code, CAN/CGA-B149.2, and with local codes where applicable. • This cooktop has been design-certified by the American Gas Association according to ANSI Z21.1, latest edition and Canadian Gas Association according to CAN/CGA-1.1 latest edition. • Your cooktop must be electrically grounded in accordance with local codes or, in the absence of local codes, in accordance with the National Electrical Code (ANSI/NFPA 70, latest edition). In Canada, electrical grounding must be in accordance with the current CSA C22.1 Canadian Electrical Code Part 1 and/or local codes. Design Information Models Available ........................................................... 3 Accessories ..................................................................... 3 Dimensions and Clearances ......................................... 3 Advance Planning ......................................................... 4 Ductwork Advance Planning ........................................ 4 Tools and Materials Required ...................................... 4 Cabinetry/Ductwork Cut the Opening ........................................................... 5 Venting Options ............................................................ 6 Ductwork Fittings .......................................................... 7 Power Supply Locations ............................................... 8 Contents Installation Step 1: Install Downdraft Vent ..................................... 9 Step 2: Install Ductwork ............................................. 10 Step 3: Install Pressure Regulator.............................. 10 Step 4: Install the Cooktop ........................................ 11 Step 5: Electrical Connections ................................... 12 Step 6: Connect Power ............................................... 12 Step 7: Assemble Burners, Check Ignition ............... 12 Step 8: Install Filters, Check Operation of Downdraft ................................. 13 JXRB57 Kit, Indoor Remote Blower Location ........ 14 JXBC57 Kit, Outdoor Remote Blower Location ...... 17 Design Information Gas Downdraft Cooktop ZGU365 Models 36" gas downdraft cooktops Available These models are shipped for natural gas operation. They can be converted to liquid propane. (Order JXLP56 conversion kit.) Accessories These gas downdraft cooktops are equipped with an vent system which can be retracted when not in use. • JXBA56WW, white or JXBA56BB, black motor and blower assembly is required for both models. Be sure to order the color that matches the cooktop. • JXRB57 optional accessory for indoor remote location of the blower/motor assembly. Use this kit when the blower and motor assembly will be located outside of or below the cabinet floor. •JXBC57 optional outdoor cover accessory may be ordered for installation of blower and motor assembly on the outside wall. Dimensions and Clearances 8-3/4" 15" 36" 19-3/4" 2" 2" 2-1/4" 7" 12-3/8" 5-3/8" 3-1/4" 7-1/2" 6-3/8" 2" 8-1/2" Lift When Installed 3-1/4" 13" Max. 3-7/8" Min. From Cooktop to Rear Vertical Combustible When Installed 8" Min. to Wall When Installed Both Sides 1-1/2" Min. 18" Min. 30" Min. 14-3/4" 36" 33-3/4" 26" 27" Design Information Gas Downdraft Cooktop Advance Planning The combined installation of a downdraft vent and cooktop require careful...