Stimmen - 0, Durchschnittliche Bewertung: 0 ( )

Hersteller: Philips Dateigröße: 4.85 mb Dateiname: Unterrichtssprache:

the wall socket. Problem Cause Solution You have not switched on the appliance. GC8325/GC8320/GC8261/ GC8260/GC8225/GC8220: Press the on/off button. GC8210: set the on/off switch to ‘on’. The set temperature is too low. Set a higher temperature. Smoke comes out of my new iron when I switch it on. Some par ts of the appliance have been lightly greased in the factor y and may initially give off some smoke when heated. This phenomenon is normal and ceases after a shor t while. The iron does not produce any steam. There is not enough water in the water tank. Fill the water tank. See chapter ‘Preparing for use’, section ‘Filling the detachable water tank’. The steam generator has not heated up sufficiently. Wait approx. 2 minutes. GC8325/ GC8320/GC8261/GC8260/ GC8225/GC8220 only: wait until the steam light stays on continuously. The set ironing temperature is too low for steam ironing. Set a temperature of 2 or higher. GC8325/GC8320/GC8261/GC8260/ GC8225/GC8220 only:You have set steam setting a(no steam). Set steam setting ] (minimum steam), [ (moderate steam) or p(maximum steam). 16 EnGliSh You have not placed the water Place the water tank properly in the tank properly in the steam generator. steam generator (‘click’). Problem Cause Solution When the iron is set to a ver y high temperature, the steam produced is dr y and hardly visible. It is even less visible when the ambient temperature is relatively high and it is entirely invisible when the temperature is set to MAX. Set the iron to a lower temperature, e.g. 2, to check if the iron actually produces steam. Water droplets come out of the soleplate. The set temperature is too low for steam ironing. Set a temperature of 2 or higher. When you star t steam ironing and when you stop steam ironing for a while, the steam still present in the supply hose cools down and condenses into water. This causes water droplets to come out of the soleplate. This is normal. When you star t ironing or when you continue ironing after an interruption, hold the iron over an old cloth and press the steam trigger. Wait until steam instead of water comes out of the soleplate. Flakes and impurities come out of the soleplate or the soleplate is dir ty. Impurities or chemicals present in the water have deposited in the steam vents and/or on the soleplate. Clean the soleplate with a damp cloth. The appliance produces a pumping sound. Water is pumped into the steam generator. This is normal. The pumping sound does not stop. Unplug the iron immediately and contact an authorised Philips ser vice centre. The iron produces steam continuously. The steam lock has been set to ‘on’. Set the steam lock to ‘off ’ if you only want to obtain steam when you press the steam trigger (see section ‘Steam lock function’). Dir ty water comes out of the soleplate. Too much scale and minerals have accumulated inside the steam generator. Rinse the steam generator. See chapter ‘Cleaning and maintenance’. Steam escapes from under the Calc- Clean rinsing cap when the appliance heats up. You have not tightened the Calc-clean rinsing cap properly. Switch off the appliance, tighten the Calc-...

Herunterladen

Geben Sie zwei Ziffern: