Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
Fig 3 • 50% untreated tap water with 50% distilled or demineralized bottled water 4) Once removed from the main body, turn the Water Reservoir up to show the grey stopper. (Fig 3) 5) Grasp the tab on the stopper and gently pull the stopper out (Fig 4). Remove it only enough to allow for adding water. DO NOT break the connecting elastic band. Fig 4 6) Add water to the reservoir thru the stopper hole until the reservoir is full. Do not overfill. Carefully replace the stopper and close it securely aligning the tab as shown (Fig. 3). 7) Replace the Water Reservoir into the main body of the appliance. With the Quick-Release tabs at the inner bottom, slide the Water Reservoir in until the tabs clip securely (Fig 1).r Water Reservoir Stopper Tab Water Reservoir Stopper 877-HAAN DIRECT / 877-422-6347 pg 7 Using Your QuickPro™ Portable Steamer & Sanitizer Fig 5 Operating Instructions: (cont) 8) With the appliance sitting on the Metal Resting Tray, plug the HAAN® QuickPro™ into a polarized outlet. This will start the heating cycle. 9) Once the Indicator light has illuminated RED, the appliance is ready to use. This should take no more than 30-40 seconds. 10) Lift the QuickPro™ off the Metal Resting Tray (Fig 5). To activate the steam jets press and hold the Continuous Steam ON/OFF button. You will hear the water pumping thru the heating unit and the steam being expelled. Begin steaming with the steamer HELPFUL HAAN® HINT: plate facing away from you. Hold the appliance parallel to the fabric surface, keeping a distance 11) When you no longer see water in the reservoir through the of 1.5” between the Steam Plate clear Water Level Window (Fig. 6), or if steam stops coming and the fabric. Slow guided out of the Steam Plate, place the unit on the Metal Resting motions are best. Tray and unplug the appliance. Fig 6 12) Allow the appliance to cool, approximately five (5) minutes before adding water to the reservoir by following steps 3-7. 13) If you are finished using the QuickPro™, allow the appliance to cool completely and empty any water left in the reservoir before storing it away. NEVER leave the appliance plugged in and unattended. Always empty the Water Reservoir after use. NOTE: Heat concentrates the elements contained in water during evaporation. The types of water listed here may contain organic waste, minerals or chemical elements that can cause spitting, brown staining or premature wear on the appliance. The manufacturer recommends against the use of any of these HELPFUL HAAN® HINT: water sources: The HAAN® QuickPro™ steam plate gets very hot during use. • water from clothes dryers Use caution while using this • scented or softened water appliance. As it heats, the • water from refrigerators, batteries or air conditioners housing becomes warm. This is normal. Water Level Window pg 8 877-HAAN DIRECT / 877-422-6347 Using Your QuickPro™ Portable Steamer & Sanitizer Fig 7 Operating Instructions: (cont) • rain water • boiled, filtered or bottled water • water from refrigerators, batteries or air conditioners • use distilled or demineralized water only as advised on page 7. using the Combination Lint/Nap Brush Accessory Attachment: Fig 8 1) Before plugging the appliance in and while the Steam Plate is cool, attach the Combination Lint/Nap Brush Accessory by snapping it onto the Steam Plate. 2) On the both sides of the QuickPro™ you will see two (2) raised ridges near the Steam Plate (Fig 7). These correspond to the clip tabs on the accessory (Fig 8). 3) Push the Combination Lint/Nap Brush Accessory onto the Steam Plate until the clip tabs snap securely onto the ridges. Fig 9 This allows the Steam Jets clear access to help freshen the fabric (Fig 9). 4) Plug in the QuickPro™, wait for the Indicator light to turn Red and then use the appliance as described in Step 10 of the previous section. Use the textured surface of the accessory to remove hair, dust or lint from garment surfaces as you steam. The brush bristles can be used to freshen and lift the nap on the fabric as you sanitize the surface. 5) The QuickPro™ can be used to remove most fresh, wet spills and stains from fabrics. Hold the Steam Plate over the fresh stain and use the steam jets to penetrate the area. Use the Brush bristles to rub the saturated area gently. Take an absorbent towel and blot the area. Repeat as necessary until the stain is lifted. 6) When finished using the QuickPro™, unplug the unit and allow the appliance to cool completely while on the Metal Resting Tray. Remove the accessory attachment; it will snap off easily. Empty any residual water in the reservoir before storing the unit. raised ridges clip tabs Textured surface Brush Bristles Fig 10 Use Brush Bristles & steam to loosen stain 877-HAAN DIRECT / 877-422-6347 pg 9 Care & Maintenance IMPORTANT Always be sure that your HAAN® QuickPro™ is UNPLUGGED from the electrical outlet prior to cleaning or before emptying the Water Reservoir. CAUTIO...
Dieses Handbuch ist für folgende Modelle:Bügeleisen - QUICKPRO TS-30 (1.01 mb)