Hersteller: HP
Dateigröße: 237.6 kb
Dateiname:
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
3
2
1
HP
StorageWorks
HSV450
4
UID
5
ESC
ENTER
6
gl0127
Figure 1 Controller status LEDs
Table 1 Controller status LEDs
Item
LED
Indication
Figure 2 Removing the front bezel
1
Solid amber indicates a boot failure.
NOTE:
2
Controller health OK. Flashing green
To provide clarity, the control er enclosure is shown out of the
during boot. Solid green LED after boot.
cabinet in subsequent figures showing component removal.
Link to the other array controller. Solid
3
green indicates a connection. Amber
indicates the control ers are not connected.
4. Remove the operator control panel (OCP).
Disk drive status. Solid green when
a. Squeeze the OCP latch tabs (1, Figure 3) and swing the panel
4
devices and loops are present. Amber
out until fully open (2).
indicates a drive problem.
CAUTION:
Bat ery status. Solid green indicates all
5
fan units are normal. Amber indicates one
Handle the OCP by its metal frame only. This ensures
or more bat ery units have failed.
that the electronic components are not damaged by static
discharge.
6
Blue LED used to identify a specific
controller enclosure.
b. Grasp the OCP by its metal frame and pull it out of the
enclosure (3).
Removing components from a controller
enclosure
1. Halt I/O to the controller enclosure being replaced with HP
Command View EVA:
a. In the navigation pane, select the array. The Initialized Storage
System Properties window opens.
b. Click the Shut down tab. The Shutdown Options window
opens.
c. In the Controller Shutdown section, select the controller to
power down, and click Power down.
2. Disconnect the Fibre Channel, serial (RJ45), and power cables
from the rear of the controller enclosure. Ensure they are marked
to facilitate reconnecting later.
Figure 3 Removing the OCP
3. Remove the front bezel by grasping the bezel at each end and
pul ing it off the enclosure (Figure 2).
5. Remove the cache batteries. Some controller enclosure models
have a cache bat ery located behind the removed OCP.
a. Move the battery mounting latch (1, Figure 4) to the right and
grasp the pull handle.
b. Position one hand under the bat ery, and pull the battery out
of the enclosure (2).
Page 2
...Dieses Handbuch ist für folgende Modelle:
Media Storage - HP EVA6400 for Storage Centric Rack (237.6 kb)
Media Storage - HP EVA8400 Array (237.6 kb)