Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
HP StorageWorks
About this document
Disk enclosure power
This document describes the procedure for replacing the power
supply/blower assembly in MSA30, MSA1000, EVA3000/5000, and
supply/blower replacement
EVA4x00/6x00/8x00 products.
instructions
NOTE:
Because this component is used in several products, the drawings
may reflect a different enclosure than the one you have. The
removal and replacement procedure is the same for each product.
Warranty information
If the product in which this part is being replaced is stil under
HP warranty, then the replacement part(s) referred to in these
Replacement Instructions is provided under the terms and conditions
These instructions apply to the MSA30, MSA1000,
of the Hewlett-Packard Company Limited Warranty for that
product. A copy of this Limited Warranty may be viewed at:
EVA3000/5000, and EVA4x00/6x00/8x00
ht p://h18006.www1.hp.com/products/storageworks/warranty.html
product families. The part may also be used in other
If this is a trade sale part (product out of warranty), then the replacement
HP products. See the documentation for your product
part(s) referred to in these Replacement Instructions is provided under
for detailed replacement instructions.
HP's express limited warranty statement, which may be viewed at:
ht p://customerops.corp.hp.com/1sw/pdm_om/warranty_support/
policies/2330100.doc
The replacement part takes on either the Limited Warranty Period of the
part being replaced or a ninety-day period that begins upon installation
of the replacement part, whichever is greater.
The only warranty for this replacement product is as noted above.
Nothing in these replacement instructions should be construed as
constituting an additional warranty. The information provided in these
replacement instructions is provided "AS IS" and HP is not liable for
technical or editorial errors or omissions contained herein.
© Copyright 2005 Hewlett-Packard Development Company, L.P.
Fourth edition June 2007
Before you begin
The information in this document is subject to change without
notice.
Observe the following precautions when replacing the power
supply/blower:
Printed in Puerto Rico
• You have only seven minutes to perform the replacement procedure!
www.hp.com
Both power supplies must be installed for the enclosure to cool
properly. If a power supply fails, leave it in place in the enclosure
until a new power supply is available to install. The enclosure could
shut down due to overheating unless the power supply is replaced
within seven minutes of removal of the failed/failing power supply.
• If cabling is obstructing access to the power supply/blower, carefully
move the cables out of the way to avoid loosening any connections.
• Parts can be damaged by electrostatic discharge. Use proper
anti-static protection.
• Have a copy of the product user guide available for reference. You
can download a copy of the user guide from the product support
page on the HP website.
Verifying component failure
The power supply and blower are separately replaceable components.
Before replacing a power supply or blower, use the fol owing methods
to verify component failure.
MSA products
• Check the power supply/blower status indicator (Figure 1). It should
*5697-6790*
be off.
Page 1
...Dieses Handbuch ist für folgende Modelle:
Media Storage - HP MSA30 S-B CTO Chassis (831.56 kb)
Media Storage - HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf (831.56 kb)
Media Storage - HP MSA30 with (14) 300GB SCSI and MSA1510i Shelf (831.56 kb)
Media Storage - HP StorageWorks MSA30 DB Enclosure (831.56 kb)