Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
Remove all of the components from the packaging and place them on an antistatic surface until you are ready to use them. If you are using new disk drives, place them so they acclimate to room temperature before you install them in the enclosure and power on the system. Before continuing, inspect the components for shipping damage. Ensure that you have the tools you require for rack or tower assembly installation: ¦ Phillips-head screwdriver ¦ Wrench for tightening nuts (if your rack does not have threaded holes) Installing the Storage Enclosure Installing the Storage Enclosure ¦ Make sure that the mounting hardware and tools are easily accessible before you begin, and plan to have someone assist you during physical installation. ¦ Decide on a suitable location for the rack (if you plan to mount your Storage Enclosure into a rack). Choose a clean, dust-free, well-ventilated area close to a grounded power outlet. Leave enough room behind the rack for servicing and to allow for sufficient airflow. ¦ Decide on a suitable location for the subsystem in the rack. Warning: Prevent instability due to top-heaviness by installing heavier items into the bottom of the rack. Step 2: Installing into a Rack or Tower (optional) Note: Mounting rails for rack installation are sold separately. To purchase a rail kit, see your Adaptec reseller. Follow the instructions in this section if you are installing your Storage Enclosure into a rack or tower assembly. (A tower assembly is also known as a deskside assembly or pedestal.) If you are not installing your Storage Enclosure into a rack or tower, skip to Step 3: Installing the Drive Carriers on page 2-9. ! Caution: A fully loaded enclosure is heavy. Avoid personal injury by obtaining help to lift the Storage Enclosure, and reduce the weight of the enclosure by removing the drive carriers before installing the enclosure in the rack or tower. (You can also remove the two APCs to further reduce the weight, if required. See page 4-4 for instructions.) ¦ To install into an rack, see page 2-4. ¦ To install into a tower assembly, see page 2-7. Installing the Storage Enclosure Installing the Storage Enclosure Begin the installation by ensuring that you have all these rail kit components: ¦ Front rails (1 left, 1 right) ¦ Rear rails, two different sizes (2 left, 2 right) ¦ Two sizes of screws (10 large, 4 small) ¦ Two types of nuts (10 of each) To install your Storage Enclosure in a rack: Secure the front rails to the front supports of the rack, using the supplied screws, as shown in Figure 2-1. Note: Use either the speednuts or cagenuts provided if your rack does not have threaded holes. Figure 2-1 Securing the Rails to the Rack Check the length between the front and rear supports of your equipment rack and determine which set of rear rails to use, the long or the short. Installing the Storage Enclosure 3 Secure the rear rails you selected to the rear supports of the equipment rack, using the supplied screws, as shown i...
Dieses Handbuch ist für folgende Modelle:Andere - Adaptec FS4100 JBOD (987.52 kb)
Andere - Adaptec FS4500 RAID (987.52 kb)