Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Raritan Computer Dateigröße: 206.88 kb Dateiname: mc-ip-0A-E.pdf Unterrichtssprache:

Your MasterConsole IP (MCIP) unit is designed for quick, easy installation and operation: 1. Set up one-tier MCIP configuration. 2. Install MCIP and connect computers. 3. Configure MCIP software. 4. Assign computer names and set channel- specific scan rates for attached computers. 5. Turn ON security and change passwords to restrict access to computers connected to MCIP. 6. Operate MCIP using the On-Screen User Interface. I. One-tier Configuration Your MasterConsole IP can be configured in a one-tier configuration, in which up to 8 (with MCIP18) or 16 (with MCIP116) computers can be connected to a single MCIP unit. II. Installation 1. Power OFF all computers to be connected to the MCIP unit. 2. Plug a keyboard, monitor, and mouse into the keyboard, monitor, and mouse ports on the rear panel of the MCIP. 3. Power ON MCIP. 4. Using an MCIP cable (CMCIP20, 40, or 90), plug the 15-pin connector into one of the numbered channels on the MCIP rear panel. 5. Plug the cable's other connectors into the computer's keyboard, monitor, and mouse ports. 6. Power ON the connected computer. 7. Select the connected computer using the OSUI (see next section). Verify that the monitor attached to the MCIP unit displays the video for the connected computer. Use the keyboard and mouse attached to the MCIP to verify that they operate the connected computer. 8. Repeat steps 4 through 7 to connect the remaining computers to MCIP. III. On-Screen User Interface (OSUI) Operation After connecting your computers to your MCIP, explore MCIP operation and view factory default names and parameters. To activate the On-Screen User Interface ( OSUI), press the left CTRL key on your keyboard three times rapidly. The Selection Menu appears. Use the up and down arrow keys on your keyboard to highlight a channel (computer) on the OSUI and press Enter OR press the desired computer's Key Number, as listed in the left column of the OSUI. To select a different computer, re-activate the OSUI ([Left CTRL] three times rapidly). IV. MCIP Software Configuration 1. Activate the OSUI by pressing the Hot Key (default: [Left CTRL]) three times rapidly. When the OSUI appears, press F4 to access the Configuration Menu. 2. Use the Tab or the Shift + Tab keys to move forward or back in the list and highlight the desired field. Make your changes as follows: a. To change Name (default is the unit's model number): Move to Name and type a name up to seven characters. This field is used for identification purposes only. b. To turn AutoScan ON/OFF (default is OFF): Move to Scan and press the up/down arrow keys to toggle. If you exit the OSUI with AutoScan ON, MCIP will scan according to the currently set mode (Individual/Global) and scan rate. - To change the Global Scan Rate (default is 3 seconds): Move to Set and type a number from 01 to 99, or press the up/down arrow keys to specify the Scan Rate (in seconds) for Global AutoScan. - To change AutoScan mode (default setting is Global): Move to Mode and press the up/down arrow keys to toggle between Global and Individual. c. To turn AutoSkip ON/OFF (default is OFF): Move to Skip and press the up/down arrow keys to toggle. With AutoSkip O...

Herunterladen

Geben Sie zwei Ziffern: