Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
To prevent damage to the elliptical, the assembly instructions must be reviewed and corrective actions should be taken. UNPACKING Unpack the product where you will be using it. Place the product on a level flat surface. It is recommended that you place a protective covering on your floor. During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended. Before proceeding, find your elliptical's serial number located on the front stabilizer tube and enter it in the space provided below. Also locate the model name which is located on the side cover badge. ENTER YOUR SERIAL NUMBER AND MODEL NAME IN THE BOXES BELOW: SERIAL NUMBER: MODEL NAME * Refer to the SERIAL NUMBER and MODEL NAME when calling for service. * Also enter this serial number on your Warranty Card. s § § II c;?s cjïn S23 as 2>S «ri CïCi S35 D33 -es «'»g es TOOLS INCLUDED □ 5mm L Wrench □ 5mm T Wrench □ Phillips Screw Driver □ 13/17mm Flat Wrench PARTS INCLUDED □ 1 Console □ 1 Console Mast Boot □ 1 Console Mast □ 1 Top Cap □ 2 Upper Handlebars □ 2 Roller Wheel Covers □ 2 Lower Handlebars □ 5 Hardware Bags □ 2 Lower Link/Pedal Arms □ 1 Power Supply □ 2 Pedal Arm Covers □ 1 Audio Adaptor Cable □ 2 Pivoting Foot Pads □ 2 Elbow Covers Sets □ 2 Handlebar Cover Sets □ 2 Guide Rail Caps l§ sl CD 15^ If you have questions or if there are any missing parts, contact Customer Tech Support. Contact information is located on the back panel of this manual. For a complete exploded diagram, visit us at CE6.0_Rev.1.3.indd 6-7 ASSEMBLY STEP 1 B) Slide the CONSOLE MAST BOOT followed by the TOP CAP over the CONSOLE MAST. C) Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the CONSOLE MAST. D) Attach the sides of the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C). E) Attach the front of the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (A), 2 SPRING WASHERS (B) and 2 ARC WASHERS (D). F) Slide CONSOLE MAST BOOT down to seal the console mast hole. ASSEMBLY STEP 2 || c;?s §5^ ^*¡3 53=5 Ci!>i A) Slide GUIDE RAIL CAPS into the GUIDE RAIL to seal the openings. S23 as