Stimmen - 1, Durchschnittliche Bewertung: 5
(
)
)
|
Anleitung Zusammenfassung
ADD-ON KIT WARNING: Read and follow all directions for each step to insure proper asembly of this product. ASSEMBLY INSTRUCTIONS CLASS H 1 PART # 7016801 Version: 216101 REV. B Revision: 03/23/01 PARTS LIST KEY PART # DESCRIPTION QTY KEY PART # DESCRIPTION QTY 1 6939201 WEIGHT PLATE 5 3 6978101 WEIGHT STACK LABEL 1 2 7095801 WEIGHT STACK SHAFT 1 4 6382301 WEIGHT PLATE BUSHINGS (10 CT) 1 STEP 1: • Insert two WEIGHT PLATE BUSHINGS (4) into each of the five WEIGHT PLATES (1) as shown in FIGURE 1. 2 STEP 2: • Unscrew the WEIGHT STACK CABLE from the 15 HOLE WEIGHT STACK SHAFT as shown in FIGURE 2. • Remove the WEIGHT STACK PIN from the 15 HOLE WEIGHT STACK SHAFT as shown. STEP 3: • CAREFULLY remove or loosen bolts in the TOP BOOM to allow the GUIDE RODS to be tilted. Refer to the GYM ASSEMBLY INSTRUCTIONS . • Tilt the GUIDE ROD S back and remove the SHAFT COLLARS, HEAD PLATE ASSEMBLY, fifteen WEIGHT PLATES, two WEIGHT STACK CUSHIONS, two 3/4” WASHERS, and two WEIGHT STACK SPACERS as shown in FIGURE 3. (NOTE: Please discard the two 3/4” WASHERS, and the two WEIGHT STACK SPACERS.) 3 STEP 5: • Insert the two GUIDE RODS through the two WEIGHT STACK CUSHIONS into the base as shown in FIGURE 5. Lubricate the GUIDE RODS with a silicon or teflon spray that is available at most hardware stores. • USING EXTREME CARE, slide the five new WEIGHT PLATES (1) and the previous fifteen WEIGHT PLATES down over the GUIDE RODS onto the WEIGHT STACK CUSHIONS. (NOTE: Make sure that the key holes of the WEIGHT PLATES all face the same way.) • Carefully slide the new HEAD PLATE AS SEMBLY and the SHAFT COLLARS down over the GUIDE RODS onto the weight stack as shown in FIGURE 5. STEP 4: • Remove the E-RING and the old WEIGHT STACK SHAFT from the HEAD PLATE. (NOTE: Please discard the old WEIGHT STACK SHAFT.) • Slide the new 20 HOLE WEIGHT STACK SHAFT (2) thru the hole in the HEAD PLATE and lock in place using the previously removed E-RING as shown in FIGURE 4. 4 STEP 6: • Assemble the WEIGHT STACK PIN to the 20 HOLE WEIGHT STACK SHAFT as shown. • Screw the WEIGHT STACK CABLE into the 20 HOLE WEIGHT STACK SHAFT of the HEAD PLATE until the CABLE slightly pulls on the HEAD PLATE. • TIGHTEN cable jam nut securely! • CAREFULLY assemble and SECURELY tighten any previosly removed or loosened bolts in the TOP BOOM to allow the GUIDE RODS to be secured. Refer to the GYM ASSEMBLY INSTRUCTIONS . Thank you for purchasing the Parabody 216101 50 LB. ADD-ON KIT. If unsure of proper use of equipment, call your local LifeFitness distributor or call the Parabody customer service department at (800) 328-9714. 5...