Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
• When adjusting height or moving system, keep hands and fingers away from moving parts. • Do not allow children to move or adjust system. • During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net. • Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration. • Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace pole immediately. • Check system before each use for proper ballast, loose hardware, excessive wear and signs corrosion and repair before use. • Check system before each use for instability. • Never play on damaged equipment. • Keep pole top covered with cap at all times. • See instruction manual for proper installation and maintenance. Read and understand warnings listed below before using this product. Failure to follow these warnings may result in serious injury and/or property damage. ID#: 588000 05/05 In the U.S.: 1-888-713-5488 In the U.S.: 1-800-558-5234 In Canada: 1-800-284-8339 In the U.S.: 1-800-334-9111 In the U.S.: 1-800-558-5234 In Canada: 1-800-284-8339 #7 (1) #3 (4) #4 (2) #5 (2) #6 (1) 2 ID# 21112201 11/05 SAFETY INSTRUCTIONS FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY. Owner must ensure that all players know and follow these rules for safe operation of the system. To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. Check entire box and inside all packing material for parts and/or additional instructional material. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document. • If using a ladder during assembly, use extreme caution. • Two (2) people are recommended for this operation. • Seat the pole sections properly. Failure to do so could allow the pole sections to separate during play. • Before digging, contact utility company to locate underground power cables, gas, and water lines. Ensure there are no overhead power lines within 20 ft. (7 m) radius of pole location. • Climate, corrosion, excessive use, or misuse could result in system failure. • If technical assistance is required, contact Huffy Sports. • Minimum operational height is 6' 6" (1.98 m) to the bottom of backboard. • This equipment is intended for home recreational use only and NOT excessive competitive play. • Read and understand the warning labels. • The life of your basketball pole depends on many conditions. The climate, placement of the pole, the location of the pole, exposure to corrosives such as pesticides, herbicides, or salts are all important. • Adult supervision is recommended when adjusting height. • Serious injury could occur if teeth/face come in contact with backboard, net, or rim. Most injuries are caused by misuse and/or not following instructions. Use caution when using this system. 3 11/05 ID# 21112201 ID# 21112201 11/05 4 1. 2. Ensure ground is level with playing surface, then dig pole hole. CONTACT UTILITIES BEFORE DIGGING. WARNING! BOTTOM TOP POLE(S) NOT INCLUDED. FOLLOW MANUFACTURERS INSTRUCTIONS ACCORDINGLY. POLE STYLE WILL VARY NOTE: 24" (61 cm) 24" (61 cm) 6" (15.2 cm) GROUND SURFACE PLAYING SURFACE IMPORTANT! Maximum distance from edge of hole to edge of playing surface: 6” (15.2 cm). 3. Insert bottom pole section into ground sleeve (1). 1 Insert bottom pole section into ground sleeve (1). 1 4. Assemble clamps (4) around bottom pole and ground sleeve (1) as shown. 25 4 1 4 3 IMPORTANT! Clamp assembly MUST be positioned as shown below. 4 5. Fill hole approximately 1/3 full with mixed concrete. 5 11/05 ID# 21112201 ID# 21112201 11/05 6 Insert ground sleeve assembly and center in hole (FIG. A). Note: Leave 1" below flange exposed for drainage hill. 1" (2.54 cm) SIDE VIEW 6. IMPORTANT!: CONTINUE ON TO NEXT STEP. DO NOT WAIT FOR CONCRETE TO CURE. PLAYING SURFACE PLAYING SURFACE FIG. A IMPORTANT! NOTE POSITION OF GROUND SLEEVE IMPORTANT! FRONT OF POLE MUST BE PARALLEL WITH PLAYING SURFACE. PLAYING SURFACE 7 11/05 ID# 21112201 7. Fill hole completely with concrete. 1" (2.54 cm) 1" (2.54 cm) FILL TO HERE 8. Tamp down concrete to release air pockets and build drainage hill. Level pole section in all directions several times while concrete is curing. 1" (2.54 cm) SIDE VIEW DRAINAGE HILL IMPORTANT!: CONTINUE ON TO NEXT STEP. DO NOT WAIT FOR CONCRETE TO CURE. IMPORTANT!: WAIT A MINIMUM OF 24 HOURS BEFORE GOING ON TO NEXT STEP. CONCRETE MUST CURE. PLAYING SURFACE 9. 9. After concrete has cured, remove clamp assembly and lift bottom pole section from ground sleeve as shown. 8 ID# 21...