Stimmen - 4, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
Keys neither assumes nor authorizes anyone to assume for it any other express warranty. PLEASE SEND IN THE ATTACHED WARRANTY CARD WITHIN TEN (10) DAYS OF PURCHASE TO REGISTER YOUR UNIT WITH KEYS FITNESS PRODUCTS, LP. MAIL WARRANTY CARD TO: KEYS FITNESS PRODUCTS, PO BOX 551239, DALLAS, TX 75355 1 Before You Start Before You Start Safety Precautions and Tips Thank you for purchasing a Keys Elliptical Trainer! This quality product you have chosen was designed to meet your needs for cardiovascular exercise. Prior to assembly, remove components from the box and verify that all the listed parts were supplied. Assembly instructions are described in the following steps and illustrations. Important Safety Information WARNING! 1) Before using this exercise unit or starting any exercise program, consult your physician. This is especially important for persons over the age of 35 and/or persons with preexisting health problems. Keys Fitness Products LP assumes no responsibility for personal injury or property damage sustained by or through the use of this product. 2) To reduce the risk of electrical shock, burns, fire or other possible injuries to the user, it is important to review this manual and the following precautions before operation. 2 It is the owner's responsibility to ensure that all users of this exercise unit have read the Owner's Manual and are familiar with warnings and safety precautions. • This ellptical trainer has a user maximum capacity of 300 pounds. • The Keys Elliptical Trainer should only be used on a level surface and is intended for indoor use only. It should not be placed in a garage, patio or near water. Keys recommends an equipment mat be placed under the unit to protect the floor or carpet and for easier cleaning. • Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not use this exercise unit with bare feet, sandals, socks or stockings! • Always examine your elliptical trainer before using to ensure all parts are in working order. • Do not leave children unsupervised near or on the exercise unit. • Never operate the elliptical trainer where oxygen is being administered or where aerosol products are being used. • Never insert any object or body parts into any opening. • Service to your Keys Elliptical Trainer should only be performed by an authorized service representative, unless authorized and/or instructed by a Keys technician. Failure to follow these instructions will void the warranty. 3 Assembly of CardioMax 835D Elliptical Trainer Assembly of CardioMax 835D Elliptical Trainer REMOVE ALL SECURITY TAPE AND WRAPPING BEFORE BEGINNING. 1. Attach the Aluminum Extrusions (45) to the Main Frame Assembly (1) with Screws (63). Connect the Aluminum Extension Plate (34) between the Extrusions (45) with Screws (64). 2. Attach both the Left and Right Rear Foot Frames (32, 33) to the Left and Right Front Foot Frames (30,31) with Screws (62) and Locknuts (49). 2 1 4 5 4343 3. Connect the Controller Extension Wire (28) in the Main Upright (2) to the Controller Wire in the Main Frame Assembly. Also, connect the Tension Control Wire in the Main Upright to the Reed Switch Wire (27) in the Main Frame Assembly as shown in the diagram. Then slide the Main Upright (2) onto the Main Frame Assembly (1) and secure with Screws (56), Flat Washers (50) and Locknuts (49). 4. First connect the Controller Wire (28) to the Console (5). Then connect the Monitor (5) to the Main Upright (2) with the Screws (59) already supplied in the back of the Console. 67 5656 5. First connect the Pulse Wire (26) from the T-Shaped Handlebar (10) to the Pulse Wire from the Console. Then connect the T-Shaped Handlebar (10) to the Main Upright (2) with Screws (55), Flat Washers (50) and Locknuts (49). 6. Curved Washers (79) should already be on Main Upright posts. Slide the left and right handlebars (3, 4) onto the Main Upright (2). Secure handlebars with Washers (61), Snap Caps (21), Washers (69), Nuts (52), and Bushing Caps (22). 89 7878 7. Secure the Connecting Arms (29) to the left and right handle-8. Insert the batteries provided into the back of the Monitor (5) bars (3, 4) with Screws (67), Washers (69) and Nuts (68). 10 11 99.You have completed the assembly of your CardioMax 835 Elliptical Trainer. 99.You have completed the assembly of your CardioMax 835 Elliptical Trainer. 12 13 835 ELLIPTICAL PARTS LIST NO. 1 2 3 4 6 7 8 9 11 12 13 14 16 17 18 19 21 22 23 24 26 27 28 29 31 32 14 PART MAIN FRAME ASSEMBLY MAIN UPRIGHT LEFT FOAM HANDLE RIGHT FOAM HANDLE MONITOR PULLEY MAGNETIC FLYWHEEL SENSOR 460 mm BELT T-SHAPED HANDLEBAR BOTTOM LEFT HOUSING BOTTOM RIGHT HOUSING TOP HOUSING CONSOLE TUBE COLLAR ROUND COVER FOOT PEDAL END CAP ROLLER CAP FOOT CAP WHEEL SNAP CAP BUSHING CAP 076mm BUSHING 016mm INNER TUBE HAND PULSE PULSE WIRE REED SWITCH WIRE EXTENSION WIRE CONNECTING ARM LEFT FRONT FOOT FRAME RIGHT FRONT FOOT FRAME LEFT REAR FOOT FRAME QTY 1 1 1 2 1 1 1 1 1 1 1 1 1 1 2 2 4 2 1 2 2 2 2 2 2 2 1 1 2 1 1...