Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
We are sure that you will be very satisfied with your selection. Although great care and effort have been taken, occasionally problems may occur. To ensure prompt and correct handling of any problems, or to answer any questions, please contact our Toll-Free Customer Service Number listed below. Service will be quicker if you have your Model Number (found on carton) and assembly instructions ready when calling. PLEASE WRITE YOUR MODEL NUMBER IN THE SPACE PROVIDED ABOVE. Toll-Free Customer Service Number for U.S: 1-800-558-5234 and Canada Only: 1-800-284-8339 Internet Address: 1 09/02 P/N 211911A © COPYRIGHT 2002 by HUFFY SPORTS HARDWARE IDENTIFIER * You may have extra parts with this model. Item #12 (1) Item #10 (6) Item #8 (5) Item #17 (12) Item #14 (2) Item #15 (10) Item #19 (8) Item #20 (4) Item #21 (2) Item #6 (1) Item #9 (1) Item #5 (1) 2 P/N 211911A 09/02 HARDWARE IDENTIFIER (continued) * You may have extra parts with this model. Item #36 (1) Item #34 (1) Item #35 (1) Item #32 (1) Item #33 (1) Item #41 (2) Item #38 (4) Item #43 (6)* Item #26 (2) 3 09/02 P/N 211911A ENGLISH INSTRUCTIONS adhere gasket (39) to inside of battery cover (40) as shown. IMPORTANT! WRITE DOWN MODEL NUMBER FROM BOX ON Install 2 “AA” batteries (not included) into rim cover (37). Be sure PAGE 1 OF THIS OWNERS MANUAL to install batteries in direction shown on inside of battery compartment. Attach battery cover (40) with screws (38) and washers (41)as shown. Turn unit on to verify correct battery installation. NOTE: The lighted feature of this product is designed for night time use in order to extend playing time after dark, and may not be readily visible during day light. WARNING: USE OF THIS PRODUCT WITHOUT PROPER INSTALLATION OF SMART CLIPS, OR WHEN ALL SMART CLIPS ARE NOT PRESENT COULD RESULT IN BODILY HARM. BE SURE TO FOLLOW DIRECTIONS CAREFULLY. 13. Install net clips as shown. (See illustration) 14. Install net as shown. (See illustration) 15. Carefully upright assembly. Apply moving system label (13) to front of pole as shown. WARNING: DO NOT LEAVE ASSEMBLED UNIT UNATTENDED WHEN EMPTY, MAY TIP OVER. 16. Place assembled unit to desired location. Fill tank with water (30 gallons (114 liters)) or sand (360 lb. (163 kg)) and snap tank cap (28) in place. Insert T-strap (27) through slot on back of base as shown. FLUSH (EVEN) WITH LOCK NUT’S OUTER EDGE. Secure unit to ground by twisting tie down stake (25) into ground 5. Secure non-secured ends of tank struts (11) to tank as shown. and hooking T-strap (27) onto tie down stake (25). Repeat for opposite side. IMPORTANT! Add two gallons (7.6 liters) of non-toxic 6. Attach extension arm (18) to pole using U-bolt (22), washers antifreeze in sub-freezing climates. (19), nuts (8), as shown. Install pole cap (24) as shown. WARNING: DO NOT LEAVE ASSEMBLED UNIT UNATTENDED, IT MAY TIP OVER. 7. Attach board struts (29) to extension arm using U-bolts (30), strap (42), and nuts (15) and bolt covers (43) as shown. Tighten completely. 8. Attach backboard to struts (29) with bolts (21) and nuts (15) as shown. Insert T-bolt (32) through back bracket (31) and attach this assembly to backboard by inserting bolts (20) through back bracket (31), backboard, backboard extension arm (18), washers (19), and nuts (15) as shown. IMPORTANT! Prevent backboard lighting wires from being damaged by keeping them in the small channel on backboard. 9. A. Fit rim (16) securely into bracket (31) as shown. B. Install reinforcement bracket (33) onto “T” bolt (32) as shown. Tuck wires from rim behind reinforcement bracket (33). C. Install spring (34) onto “T” bolt (32) as shown. D. Install special nut (36) and washer (35) onto “T” bolt (32). Tighten nut (36) until flush with end of “T” bolt (32). 10. Connect red and black wires from rim (16) to red and black wires from rim cover (37). Repeat with blue and white wires. 11. Fit rim cover (37) into rim bracket (31) and secure to rim with screws (38) as shown. 12. Remove paper backing from battery cover gasket (39) and WARRANTY CARD: Please remember to complete your product registration form either on-line at: or mail-in the enclosed postcard. 4 P/N 211911A 09/02 PARTS LIST - See Hardware Identifier Item Qty. Part No. Description 1 206740 Tank (White) 1 200628 Wheel Axle 2 226401 Wheel 1 986102 Bottom Pole Section 1 202820 Rod, 3/8 O.D. x 4-3/4 Long 1 202822 Eye Bolt, 3/8-16 x 3-3/4 Long 1 200627 Wheel Bracket 5 203063 Lock Nut, Nylon Insert, 3/8-16 1 202541 Bolt, Hex Head, 5/16-18 x 3-3/4 6 203218 Washer, 5/16 Flat 2 986206 Tank Strut 1 203220 Lock Nut, 5/16-18 1 201261 Label, Moving System 2 203156 Bolt, Hex Head, 5/16-18 x 1 Long 10 203100 Nut, Hex Flange 5/16-18 1 Rim 12 201219 Smart Clip 1 902006 Extension Arm, White 8 203309 Washer, 1 O.D. 4 203113 Bolt, Hex Flange, 5/16-18 x 2-1/2 Long 2 203038 Bolt, Carriage 5/16-18 x 2-3/4 2 201562 U-bolt, Round, 3/8-16 x 2-3/4 Long 1 Net 1 201190 Cap 1 203124 Tie Down Stake...