Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Read the Installation, Operating and Maintenance Instructions thoroughly before installing or servicing this equipment. ! ! Initial heating of appliance may generate smoke or fumes and must be done in a well ventilated area. Overexposure to smoke or fumes may cause nausea or dizziness. This equipment has been engineered to provide you with year-round dependable service when used according to the instructions in this manual and standard commercial kitchen practices. ANSI/NSF4 P/N 70202003 10/06Phone: +1 (214) 421-7366 Fax: +1 (214) 565-0976 Toll Free: +1 (800) 527-2100 APW WYOTT Website: (800) 733-2203729 Third Avenue E-mail: info@apwwyott.com 24 Hour Service Hotline Dallas, TX 75226 1 TABLE OF CONTENTS Safety Precautions 2 General Information 2 Installation 3 Location 4 Operating Instructions 4 Cleaning 5 Troubleshooting Guide 7 Replacement Parts List w/Exploded View 8 Wiring Diagram 10 Warranty 12 ! WARNING: In Europe, appliance must be connected by an earthing cable to all other units in the complete installation and thence to an independent earth connection in compliance with EN 60335-1 and/or local codes ! ! WARNING: An earthing cable must connect the appliance to all other units in the complete installation and from there to an independent earth connection. ! SAFETY PRECAUTIONS APW Wyott toasters are designed, built, and sold for commercial use and should be operated by trained personnel only. Clearly post all CAUTIONS, WARNINGS and operating instructions near each unit to insure proper operation and to reduce the chance of personal injury and/or equipment damage. Always disconnect power before cleaning or servicing the toaster. Surfaces will remain hot after power has been turned off, allow unit to cool before cleaning or servicing. Never clean the toaster by immersing it in water. The toaster is not protected against water jets; DO NOT CLEAN TOASTER WITH A WATER JET. Always clean equipment before first use. Operating toaster without legs will void the warranty. Insure all accessories and exterior panels are properly installed and adjusted before applying power and operating. GENERAL INFORMATION Check the rating label for your model designation and electrical rating. Rating Label is located on the bottom front of the control panel. Overall dimensions with feeder: 23.5"(59.7cm) W x 25.9"(65.8cm) H x 17.5"(44.5cm) D Electrical Ratings: M2KA: 208VAC, 2880W, 13.8A, 60Hz M2KH: 240VAC, 3840W, 16A, 60Hz Cordset Configuration: 208/250V: NEMA6-20P Plug, 4 foot, 3 wire grounded cord. If the supply cord is damaged, the manufacturer or an authorized service agent or a similarly qualified person must replace it to avoid a hazard or warranty. Shipping Weight: 94 lbs (42.7 Kg) 2 INSTALLATION 1. Examine carton for damage The freight carrier has assumed responsibility for its safe transit and delivery. If equipment is received damaged, either apparent or concealed, a claim must be made with delivering carrier. a. Apparent damage or loss must be noted on the freight bill at the time of delivery. The carrier representative (Driver) must sign the freight bill. If this is not done, the carrier may refuse the claim. The carrier can supply the necessary forms. b. Concealed damage or loss if not apparent until after the toaster is removed from carton, a request for inspection must be made to the carrier within 15 days. The carrier should arrange an inspection. Be sure to save all contents and packaging material. 2. Verify Parts After removing unit from the shipping carton, unwrapping loose parts and remove any packing tape, plastic wrap and nylon tie-down. Verify the following parts: Item Legs Feeder/Bun Chute PackagingIn plastic bag Wrapped, loose in top of carton Qty4 1 Conveyor Instruction Manual In individual carton Loose in carton 1 1 Teflon Sheet Kit (optional) Loose in carton Optional NOTE: PRIOR TO INITIALSTART-UP, ALLREMOVABLE PARTS AND THE GRILLSURFACE SHOULD BE CLEANED WITH WARM SOAPY WATER TO REMOVE MANUFACTURING OILS, THEN RINSED AND DRIED THOROUGHLY. Apply oil (vegetable oil) to the conveyor chain after washing. (Bun oil can be used if it contains no animal fats, salts or dairy products). 3. Assemble Legs Lay the toaster on its back and install the four adjustable legs into the threaded holes on the bottom of the toaster sides. Hand tighten the legs by gripping the black shank and turning until it is seated firmly against the bottom of the toaster. Set the toaster upright on a flat surface. Unscrewing the lower, chrome insert of each leg levels the unit. Flats are provided on two sides of the insert to allow use of a wrench. “Precise” leveling is not required for proper operation. 4. Conveyor InstallationRemove the front panel by lifting it straight up. (See Figure 1) Lift conveyor assembly by using “U” shaped handles on each conveyor side bracket. Lower the conveyor into the two conveyor hanger brackets above the grill plate on each side, so the four spacers on the sides of the conveyor rest o...