Stimmen - 3, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
The cutout depth must be 24". The refrigerator will project forward, slightly beyond adjacent 194Dia4 cabinetry, depending on your installation. The cutout depth beneath a soffit: When installed beneath a soffit, the soffit cannot exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit. Frameless cabinets: The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing. The opening must allow for filler strips. Additional Specifications • A 115 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown. Note: GFI (ground fault interrupter) is not recommended. • Water line can enter the opening through the floor or back wall. The water line should be 1/4" O.D. copper tubing or GE SmartConnect™ kit between the cold water line and water connection location, long enough to extend to the front of the refrigerator. Installation of an easily accessible shut off valve in the water line is recommended. Specification Revised 1/04 36" Frame to Frame Case Width *83-1/2" at Rear 25-3/4" 27-3/4" including * Shipping height. The refrigerator can be adjusted to fit into a cutout that is 83-1/2” min. to 84-1/2” max. height 35" *84" From Note that the top Floor to Top Frame case trim at the front is 1/2” higher and will overlap upper cabinetry or soffit. Use leveling legs and wheels for a maximum 1" height adjustment. handle Product Clearances These refrigerators are equipped with a 2 position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. 15"13" 23-7/8" Behind Frame 20-5/8 4" Min. to Wall Allow minimum clearances for freezer door and fresh food door for a full 130° door swing and to allow for pan removal. 4" minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, pan access is maintained, but pan removal is restricted. Installation Information: Before installing, consult installation instructions packed with product, or available at Monogram.com, for current dimensional data. R As an ENERGY STAR® Listed by partner, GE has determined Underwriters that this product meets the Laboratories ENERGY STAR guidelines for energy efficiency. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000. ZISS360NRSS–GEMonogram36"StainlessSteelBuilt-InSide-by-SideRefrigeratorwithAutomaticIcemakerandWaterFilter ZISS360NRSS Specification Revised 1/04 Features and Benefits • 21.6 cu. ft. total capacity • Overhead evaporator • Integrated Ice™ System – The ice bucket is integrated into the icemaker, not the freezer door, freeing up valuable storage space • Upfront electronic controls with digital readout • Multi-shelf halogen light tower (Both fresh food and freezer section) • Multi-shelf air management tower • Climate control drawer with Express Chill, Express Thaw and Select Temp • Sealed adjustable humidity produce pan with easy access lid and full extension slides • Model ZISS360NRSS – Stainless steel wrap, non-dispenser As an ENERGY STAR® partner, GE has determined that this product meets the ENERGY STAR guidelines for energy efficiency. 110104 ...