Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Accusplit Dateigröße: 903.68 kb Dateiname: Unterrichtssprache:

The three dark gray pads must be facing up (away from the case back). c. Finally, put the gasket on top of the gasket holder, and gently push both into the case back until they pop into place. 8. Turn the electronics module over so that the battery is facing the inside of the case back. Gently push the electronics module down into the gray rubber gasket, until it seats. It will be firmly in position if this is done correctly. 9. Slide the button set out of the front case (you'll see that the three buttons are joined together into one assembly). 10. Turn the button actuator set so that the flat part of the buttons are facing the outside of the case back. Now, slide the button set into the top of the case back & electronics module assembly, so that the button actuator bars slide down into the slots between the top of the gray rubber gasket and the case back. 11. Now, pick up the case front, holding it so that the outside (front of the watch) is touching your palm. Put the lanyard back into its slot in the bottom of the case front. 12. Flip the electronics/case back assembly over and gently press it back into the front case of the watch, until it seats. The buttons should now work normally. 13. Replace and tighten the six screws in the case back. Screws must be tight for the watch to be water resistant again. ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA 800-935-1996 • 925-290-1900 • FAX 925-290-1930 • • support@ACCUSPLIT.com 998-310...

Herunterladen

Geben Sie zwei Ziffern: