9 TV Functions Except Teletext Functions ........................................................................... 10 Teletext Functions .............................................................................................................11 INSTALLATION .................................................................................................................. 12 GENERAL OPERATION.....................................................................................................

W260F8U/W320F8U/W370F8U PAGE 15 Language To select the different languages displayed OSD H Position To adjust the OSD position horizontally OSD V Position To adjust the OSD position vertically OSD Timeout To adjust the length of time the OSD to be displayed on the screen without any commands Blue Screen To set the Blue Screen on/off when there is no signal input in TV, AV, AV1, AV2, YPbPr modes Close Caption Only valid for U.S.A users Scaler Mode To select viewable screen modes of Fill Screen, 4

CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. . This symbol alerts the user to the fact that exposed “dangerous voltages” reside within this product’s enclosure and contact with any of these voltages will result in electric shock. This symbol alerts the user that important and maintenance (servicing) instructions in the literature accompanying the unit. To prevent electric sh

• If only one angle is recorded, “ ” is displayed. Subtitle Selection 1. While a DVD is playing, press the SUBTITLE button to display the current language setting, as shown in the example below. 2. Press the SUBTITLE button repeatedly to select the desired subtitle language. Notes: • If only one language is recorded, the language does not change. • About two seconds later, playback continues with the new subtitle selected. • The number of languages recorded differs depending on the disc. • If no

•Try and reset tne firmware. Turn of tne power and on tne top of the unit press and hokj the VOL+ and hit the Power button Once you see the Volume Increasing on the video monitor release the VOU button. •If this occurs frequerCy. please contact your dealer 55 Troubleshooting (Continued) For TV broadcasts Symptom Diagnosis / Solution Power does not qo on •Is the powor supply unplugged from tho wail outlet? (Make sure it la fi-m y ¡needed into the wail outlet) *ls the DC IN on the base unit i

The following parts will be used when installed properly: Two Bead ConDector, Bead Cb~D, Bead CbaiD CoDnector, and Bead CbaiD CoDDector Cover. (Figure 16) 3. Remove clip or pin which retains throttle cable (and washer if provided) and install Two Bead Connector on the same side of throttle cable as the Cable Assembly will be anchored. This is necessary so that Cable Asaeinbly and throttle cable will not cross. 4. The Two Bead may need to be bent so that it clears the throttle cable. (Figure 17)

Precaution on battery use Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the instructions below. . Place batteries with their terminals corresponding to the (+) and (–) indications. Using the Remote Control Batteries for Remote Control PAGE 4 . Different types of batteries have different characteristics. Do not mix batteries of different types. . Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batterie

2. Simply unplugged the DC power pin of power adapter , then unplug the AC power pin of that from the AC power supply to turn the TV off completely. Caution: The TV will be shut off automatically when the power trips. Do unplug the power adapter from the AC outlet if so. The last TV mode will appear when power resumes Please do not turn on/off the TV too often! Please unplug the power adapter from the AC outlet in time when the power is suddenly off! INSTALLATION GENERAL OPERATION PAGE 10 MENU O