Stimmen - 3, Durchschnittliche Bewertung: 3 ( )

Hersteller: Toshiba Dateigröße: 12.38 mb Dateiname: Unterrichtssprache:

5 Press the ENTER button to select Start Scan and continue with the Auto Tuning. You must select a Language, either Home/Store mode, and select ANT/CABLE before you can exit out of the Setup Menu. The EXIT button will not function until these selections have been made. 45 Setting up your TV Installation setup selection Installation setup selection Menu language You can choose from three different menu language settings (English, Francais, and Espanol) for the on-screen display of menus and messages. To select the menu language: 1 Press the MENU button and open the Installation menu, then highlight Menu Language. 2 Press the ///(arrow) buttons to select your preferred language. PictureOptionsInstallationTimersGet HelpInstallationMenu LanguageTime ZoneDaylight Saving TimeStore / Home ModeChannel TuningQuick SetupReset TVEnglishEasternOffHomeEnglishFrancaisEspanolSound (Sample Image) Selecting the menu language 3 Press the EXIT button to close the Installation menu. ANT/CABLE IN This setting configures the input source for the ANT/CABLE terminal. 1 Press the MENU button and open the Installation menu. 2 Highlight Channel Tunning, and then press the ENTER button. (Sample Image) Installation - Setup selection Installation setup selection 46 Setting up your TV Auto Tuning 3 Open the Channel Tuning menu, highlight ANT/CABLE In, and then press the ENTER button. (Sample Image) Channel tuning menu - Input configuration selection 4 Press the /(arrow) buttons to select the input source (Cable or Antenna), and then press the ENTER button to save your new settings. Storing channels in memory (optional) To make sure your TV stops only on the channels you want when you press the /(arrow) buttons on the remote control or the control panel, store those channels in the TV’s memory. Auto Tuning You can set up the TV to detect all active channels in your area and store them in its memory. Then you can manually add or erase individual channels from memory. v You must set up the ANT/CABLE input source before programming channels. See “ANT/CABLE IN” on page 45. v The automatic channel programming process will erase channels that were previously programmed into the TV’s memory. v To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. v Programming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly. To program channels automatically: 1 Configure the antenna input source, if you have not already done so, see “ANT/CABLE IN” on page 45. 2 Press the MENU button and open the Installation menu. 3 Highlight Channel Tuning, and then press the ENTER button. (Sample Image) Setup menu -...

Herunterladen

Geben Sie zwei Ziffern: