Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: LG Dateigröße: 6.46 mb Dateiname: Unterrichtssprache:

But, do not change 2 or more locations from the designated spot. > LSW200B/LSW200BG/LSW200BX/LSW200BXG : Assemble the wall mount screw on 1 left and 1 right location on the top part and 1 left and 1 right location on the bottom part. > LSW400B/LSW400BG : Assemble the wall mount screw on 2 left and 2 right locations on the top and 1 left and 1 right location on the bottom part. > At this time, use a "+" driver (Manual or motorized) or 8mm wrench to tighten the screw so that the wall, wall bracket and screw are completely pressed against one another. Wall mount screw LSW400B/LSW400BG Model a. Locate and mark the centers of the wall studs using a stud finder. b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and then remove the wall bracket. c. Use a level to make sure your screw marks are level. d. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked on the wall. e. Clean the drilled hole. f. Tighten the wall mount screws for the wall bracket on the drilled hole. > At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another. (Drywall can be damaged when tightened with excessive force, please be careful.) > When tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench. 406mm drywall 76mm drywall wood stud 1. Set the display with the guide spacer assembled on the wall mount bracket on the wall in arrow direction. At this time, align the bottom assembly part and lift the set up lightly to align the top part. 2. When adjusting the location, assemble the provide safety clip as shown in the picture to prevent the product from moving. Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off. > Pull on the bottom of the set to make sure the display is secure. > When installing a display rotated, only rotate the display 90 degrees (portrait mode). (Only applies for VESA 200X200, 400x400) > The clearance from the wall is 14mm for this product. Make sure to keep a certain level of distance from the wall so that excessive force is not applied on the cable or accessory. > When you push the product with excessive force, the product can be damaged. 4 How to assemble the wall mount support and display - Always install the display with 2 or more people. * Assemble the wall mount support, product and safety clip. Safety clip Safety clip screw 6 5 How to level the Display After installing the display, check to make sure it is level. The wall mount has two screws that make minor adjustments to the level. 6 Cable arrangement and set protection cushion - Arrange the cables as shown in the picture. Use some type of cable banding device to hold all the cables together. - Attach the set protection cushion to mitigate the impact between the wall and the...

Herunterladen

Geben Sie zwei Ziffern: