Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
• This unit cannot record the contents from the built-in DVD. NORMAL RECORDING TV/VCR You can ONLY watch the same TV program that is being recorded. 1 Select the channel to be recorded Press the Number buttons or CH 10 [CH. K / L]. NOTE: • If the unit is connected to a cable box or satellite box, the unit must be on CH3 or CH4, then the channel to be recorded must be selected on the cable box or satellite box. 2 Select the tape speed Hit [SPEED] to select the desired tape speed (SP/ SLP). SP REC 3 Begin recording Hit [RECORD]. SP 4 Stop recording Hit [STOP C]. SKIPPING UNWANTED SCENES DURING RECORDING TV/VCR Hit [PAUSE F] to temporarily stop PAUSE recording. Press [PAUSE F] or [RECORD] to resume recording. SP NOTES: • After 5 minutes, the unit will automatically switch to the recording mode to prevent tape damage. • If Closed Caption mode is on, the On-Screen Display will appear for 5 seconds, then disappear. - 29 - 29- 29- 29- 29- 29- 29- 29- 29- 29- 29- ----------E EEEEEEEEEEN NNNNNNNNNN - 30 - EN This function enables you to set a recording length simply by hitting [REC/OTR] on the unit. Make sure ... • The unit must be turned on. • Insert a cassette tape with its erase-prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.) NOTES: • You cannot start OTR with the remote control. • Recording starts immediately when [REC/OTR] is hit. • When [REC/OTR] is hit 18 times, the unit returns to the normal recording mode. • To stop the OTR operation, hit [C STOP] on the unit or on the remote control. • To show the remaining time, hit [DISPLAY] on the remote control so that “OTR” appears on the TV screen. (It will show up momentarily then disappear.) • Recording stops when the display shows 0:00. • Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8 hours using T-160 (or 6 hours using T-120). • If the tape runs out before the end time, the unit will switch to the stop mode immediately, ejects the tape and turns itself off. • Even if [POWER] is hit during OTR, the unit continues recording. 1 Select the channel to be recorded Press the Number buttons or [CH. K / L]. NOTE: • If the unit is connected to a cable box or satellite box, the unit must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box. 2 Select the tape speed Hit [SPEED] to select the desired tape speed (SP/SLP). 3 Begin OTR Hit [REC/OTR] on the unit as many times as needed. The recording length will be determined by the number of times you hit [REC/OTR]. Each time it is hit, the recording time will be increased by 30 minutes up to 8 hours. TV/VCR OTR (One Touch Recording) Time(s) Display Recording length 1 time (normal recording) 2 times 0:30 30 minutes 3 times 1:00 60 minutes 17 times 8:00 480 minutes You can make copies of video tapes made by friends or relatives for your enjoyment. You can not copy a DVD to a videotape. Connect your unit and a source (Playing) VCR using the following diagram. 1)Insert a pre-recorded video cassette into the source VCR or camcorder. 2)Insert a blank video cassette or one you want to record over, into the unit’s cassette compartment. 3)Hit [SPEED] on remote control for the unit to select the desired recording speed (SP/SLP). 4)Press [CHANNEL K / L] on the unit until “AUX” appears on the screen. 5)Hit [REC/OTR] on the unit. 6)Begin playback of the tape in the source VCR or camcorder. NOTE: • For best results during copying, use the front panel controls whenever possible. The remote control might affect the source VCR’s playback operation. 7)To stop copying, hit [C / A STOP/EJECT] on the unit, then stop the tape on the source VCR or camcorder. TV/VCR COPYING A VIDEO CASSETTE (Requires a VCR or camcorder) WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws. B PLAY F.FWD D C STOP HEADPHONE A EJECT VIDEO L – AUDIO – R VIDEO OUT IN AUDIO OUT IN L R [Fig.8] [Ex: Source VCR or Audio/Video camcorder] cable (not supplied) [This unit] OTR (2 : 30) SP TIMER RECORDING AUTOMATIC TIMER RECORDING TV/VCR You may set the unit to start and end a recording while you are away. You can set 8 programs to record on specific days, daily or weekly within a 1 year period. In the example below, the timer is being set to record: DATE: July 4th, 2005 SETTING TIME: from 7:30PM to 8:50PM CHANNEL: CH61 TAPE SPEED: SP Make sure ... • If a cable box or satellite box is connected with the unit you will be limited to record only one channel, and the channel selector on the unit must be selected to the output channel of the boxes CH 3 or CH 4 and then the actual channel to be recorded must be selected on the boxes. • Clock must be set to the correct time and date before setting the timer. • The unit must be turned on to program it. • Insert a cassette tape with its erase-prevention tab in place. (If necessary, rewind or fast forward the tape to t...