Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
Remove crank, spring, directional handle, & 4 screws. Remove sealant & screws from base, remove antenna and clean surface |^| Apply sealant to all holes & attach exterior plate using the included hardware 3 □ Apply sealant to holes and attach base using the included hardware. Apply sealant to 3 screws, fill coax hole, connect coax to antenna and wrap connection with insulating electrical tape. Coax connection should be located inside vertical stalk of antenna for service. Attach antenna to base and seal all seams and screws on plate and antenna base. s THE MOBILE ELECTRONICS COMPANY SINCE 1977 ASA ELECTRONICS CORPORATION © 2010 ASA Electronics Corporation Refer to the ANHD20 Installation/Operation for additional installation details. В Install interior plate using included hardware over hole in ceiling. В Remove plate from wall and disconnect all wires and cables (note power/ground polarity & cable labels). Connect appropriate cables / wires and install new plate. Tape all coax connections....