Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
The CAM / card holder is then inserted into the CI slot on the TV.) Insert the CAM / holder card into the slot in the direction of the arrow until it is fully located. Side or Rear view of TV TO REMOVE A CI CARD When removing the CI card, make sure you pull out the CAM complete with the card fitted. This function enables you to watch the scrambled services (pay services) in some channels. If you remove the CI Module, you can only watch the available non scrambled digital programmes. 2-Press the Standby button on the remote to turn on the TV. 3-Press the INPUT button on the remote to display the Source List. Use the Up/ Down buttons to select DTV, and press the OK button. 4-If the CI card is inserted properly, the CI MODULE will briefly be displayed on screen, The contents are dependent on the CAM provider in you country. 29 10 10 Help and tips Failure Possible cause Solution The television does not function Is the power cord connected to the mains supply? Check the power cord. Is the On/Off button on? Check if the On/Off button is on. Poor picture quality (analogue TV) Is the aerial cable connected? Check the aerial cable. Aerial may be affected by two connected external devices. Try disconnecting one of the devices. It may need fine tuning. Perform fine tuning. Picture settings are not correct. Adjust Brightness, Contrast and Colour. Shadow and reflection in the picture.(analogue TV) Channel setting Perform automatic, manual channel setting or fine tuning. Aerial misaligned Check aerial direction No picture Is there any damage to the aerial or cable? Check and replace the aerial and or cable. Are you sure you pressed the correct button on your remote control? Press PR+ or PR- button to turn on the TV. No colour. Colour intensity level is at the lowest setting. Lighten the colour. Problem in channel broadcasting. Test with another channel. No or defective teletext Television channel (no teletext) or Test another channel for fine tuning and shadowy pictures Very weak signal Check the aerial system. No sound Temporary sound mute may be on Try pressing the mute button Is the sound turned down? Turn on the volume with Vol + button. Remote control does not work Are the batteries correctly placed? Place the batteries correctly. Are batteries exhausted? Replace the batteries with new ones. Is there any obstacle between the remote control and television? If yes, remove it. Picture is not visible after turning on the TV Child lock is active. Disable the child lock. If your television does not work properly even though you tried the above mentioned solutions, try turning it on and off again. If you cannot start your television even though you have applied all noted methods, refer to the dealer from where you purchased the product. Never attempt to repair a faulty device yourself. 30 11 11 Technical specifications chart SCREEN SIZE 40” Panel type 40”, 16:9 Active matrix TFT Sound output 2 x 10 W Power consumption 210 W Stand by power value <2.5 W Teletext page 250 Loudspeaker impedance: 8 Ohm Scart 1 STD Scart 2 STD Audio/Video PHONO(Input) STD S-Video socket STD YUV (Video/Sound) Component Input STD HDMI 1 STD HDMI 2 STD VGA Input STD PC Audio Input STD SPDIF Digital sound output STD Headphone socket STD Dimensions (WxDxH) 1043x316x737 Weight (Kg) 21,6 STD: Standard General technical specifications Power supply AC: 230V 50 Hz Program memory Analog: 100 RF Aerial input: 75 Ohm (Co-axial) Sound systems: Mono/Stereo/Nicam Batteries: 2xUM - 4, IEC R03 or AAA 1.5V Channels received: VHF (Band I Channel 2-4) VHF (Band III Channel 5-12) UHF (Channel 21-69) Cable TV (S1-S20/S21-S41) Broadcasting systems received PAL BG PAL SECAM BG PAL SECAM BG DK PAL SECAM BG LL’ PAL I Note: Your television has been manufactured in accordance with the system available in your country and this system cannot be changed by the user except as described below: In countries where BG/DK and BG/LL’ broadcasts are made (BG or DK / BG and LL’). For further information, see the settings section for your television. Design and specifications may be changed without prior notification. 31 12 12 MAIN UK TRANSMITTER STATIONS UHF CHANNELS STATIONS CT D Regional Main stations BBCI BBC2 ITV CH4 CH5 Map BBCI BBC2 ITV CH4 CH5 Map North West Caldbeck 30 34 28 32 56 12 Bluebell Hill 40 46 43 65 29 Winter Hill 55 62 59 65 48 15 Crystal Palace 26 33 23 30 37 28 Douglas (IOM) 68 66 48 56 56 45 Dover 50 56 66 53 30 North Oxford 49 52 64 67 31 Belmont 22 28 25 32 56 17 East Emley Moor 44 51 47 41 37 16 Sandy Heath 31 27 24 21 39 25 North East Sudbury 51 44 41 47 35 26 Bilsdale West Moor 33 26 29 23 35 14 Tacolneston 62 55 59 65 52 24 Chalton 39 45 49 42 11 Scotland Pontop Pike 58 64 61 54 56/58 13 Angus 57 63 60 53 37 6 Midlands (West) Black Hill 40 46 43 50 37 8 Ridge Hill 22 28 25 32 35 23 Cragkelly 31 27 24 21 48 7 Sutton Coldfield 46 40 43 50 37 22 Darvel 33 26 23 29 35 9 The Wreckin 26 33 23 29 25 20 Durris 22 28 25 32 67 5 Mindlands (East) Eitshal (Lewis) 33 26 ...