Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
‘a’ - + 3 4 5 6 7 8 O F F O N ‘a’ ‘y’ ‘x’ TABLE OF CONTENTS 1. FOREWORD 1 2. INTRODUCTION 1 3. SAFETY PRECAUTIONS 1 4. INSTALLATION 2 4.1 Installation Instructions 2 4.2 Installation Space 2 4.3 Location and Minimum Free Space 2 4.4 Recessed Installation 2 5. OPERATION 2 5.0 Operation 2 5.1 Initializing the remote control 2 5.2 Remote control operation 3 5.3 Manual operation 3 5.4 Thermal safety cut 3 6. CLEANING AND MAINTENANCE 3 6.1 Cleaning 3 6.2 Lamp replacement 3 7. AFTER SALES SERVICE 4 - 1 UK 1. FOREWORD This fire incorporates a flame effect which can be used with or without heating, so that comforting effect may be enjoyed at any time of the year. The flame effect is provided by a low wattage motor and three 60 watt lamps. Using the flame effect on its own, therefore, requires little electricity. The controls are located at the bottom right hand corner of the appliance (see ‘z’ in Fig 1). A choice of 750W or 1500W heat output is provided by the fan heater, which is concealed at the top of the heater (see ‘x’ in Fig 1) behind the removable front panel (see ‘y’ in Fig 1). The Valencia is designed to be inset in a fireplace opening. 2. INTRODUCTION This instruction manual gives you information about the design, operation and maintenance of your fire, as well as safety precautions and environmental recommendations. As you read this manual, you will quickly learn how to operate your fire. You will also find information about the safety and maintenance of the equipment. Read the manual carefully before using your fire and then keep the manual in a safe place. 3. SAFETY PRECAUTIONS • Have the stove installed by a qualified installer in accordance with local and national (fire safety) regulations. • Ensure that all packaging items are removed (read any warning labels carefully). • Retain all packaging until installation is complete. • The heater must be used on an ~ 230V supply and the voltage marked on the heater must correspond with the supply voltage. • Warning: This appliance must be earthed. • When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: • If the appliance is damaged, check immediately with the supplier before installation and operation. • Do not use outdoors, • Do not use in the immediate surroundings of a bath shower or swimming pool. • Do not locate the heater immediately below a fixed socket outlet or connection box. • Do not cover the heater. Do not place material or garments on the heater, or obstruct the air circulation around the heater, for instance by curtains or furniture, as this could cause overheating and a fire risk. • Do not leave young children unsupervised in the vicinity of the heater. • Ensure that furniture, curtains or other combustible material are positioned no closer than 1 meter from the heater. • In the event of a fault unplug the heater. • Although the heater complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs. • The appliance must be positioned so that the plug is accessible. • If the supply cord is damaged it must be replaced by the manufacturer or service agent or similarly qualified person in order to avoid a hazard. - 2 UK 4. INSTALLATION 4.1 INSTALLATION INSTRUCTIONS Have the stove installed by a qualified installer in conformance with national and local (fire safety) regulations. Be sure that the chimney functions properly. 4.2 INSTALLATION SPACE (see Fig. 1) A: Adjustable Feet B: Recommended built-in height C: Connection cable 4.3 LOCATION AND MINIMUM FREE SPACE Before installing read all safety warnings and operating instructions. At the base of the fire, four adjustable feet (see ‘A’ in Fig. 1) are provided for levelling the fire where the base of the fireplace opening is raised above the level of the hearth. Adjust by turning the feet until the desired height has been reached. The fire is designed to be inset in a fireplace opening - see ‘Recessed Installation’ and Fig. 2 for details. 4.4 RECESSED INSTALLATION In order to ensure it’s future safety in use, it is essential that this fire is securely fixed to the wall. IT IS IMPORTANT THAT THE FIXING DEVICE CHOSEN IS APPROPRIATE TO THE WALL MATERIAL TO WHICH THE FIRE IS BEING FIXED. SOME MODERN INTERNAL BUILDING MATERIALS ARE VERY LOW DENSITY BLOCK AND REQUIRE SPECIALIZED FIXING DEVICES TO PROVIDE A SAFE,SECURE INSTALLATION. The installation of this fire should be carried out by a competent person. Follow steps as outlined below : 1. Make sure that the fire is located on a flat surface. 2. In existing fireplaces seal all draughts and vents to prevent chimney debris from falling onto the fireplace insert. Do not install into an existing fireplace that is prone to dampness. 3. Remove the fire front panel - see ‘6.2 Lamp Replacement’ and Fig. 7. 4. Locate the 4 fixing holes, position the fire accordingly, and firmly fix the appliance to t...