Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: GE Dateigröße: 1.36 mb Dateiname: Unterrichtssprache:

Press START. Opening the door during operation will stop the dryer. To restart the dryer, close the door and press START to complete the cycle. (On some models) If the dryer is running, press once to pause the cycle; press again to continue the cycle. If the dryer is paused for more than 24 hours, the cycle will be cancelled. To stop the cycle, hold the button for 3 seconds. nOTE: Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size of load, types of fabrics, wetness of clothes and condition of exhaust ducts. f About the control settings GEAppliances.com NSF Protocol P154 Sanitization Performance of Residential Clothes Dryers R ESI D ENTIA L About the dryer features. Sensor Dry Drum lamp Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution panel by removing the fuse or switching off the circuit breaker. Reach above dryer opening from inside the drum. Remove the bulb and replace with the same size bulb. Sensor Dry (on some models) This feature is only activated in the COTTOnS, EASy CARE and DElICATES cycles. The SEnSOR DRy provides greater drying accuracy than standard machines, resulting in shorter dry times and better clothes care. As the clothes tumble, they touch a moisture sensor. The sensor will stop the heating cycle as soon as the clothes have reached the selected dryness. This dryer will adjust the initial estimated drying time of the sensor dry cycles as it "learns" its installation and usage profile. Please allow several weeks for the dryer to customize itself to "you". Drying Rack (on some models) A handy drying rack may be used for drying delicate items such as washable sweaters. Hook the rack over the lint filter so the rack extends into the dryer drum. nOTE: n The drying rack must be used with the TIMED CyClE. n Do not use this drying rack when there are other clothes in the dryer. Stainless Steel Drum (on some models) The stainless steel used to make the dryer drum provides the highest reliability available in a GE dryer. If the dryer drum should be scratched or dented during normal use, the drum will not rust or corrode. These surface blemishes will not affect the function or durability of the drum. 8 Wrinkle Care Use this option to minimize the wrinkles in clothes. It provides approximately 15 minutes of no-heat tumbling after the clothes are dry. This option can only be used with the COTTOnS, EASy CARE and DElICATES cycles. If you are using CyClE SIGnAl and you select the WRInklE CARE option, a signal will sound at the end of the drying time and several times during the WRInklE CARE cycle. This will remind you that it is time to remove the clothes. If WRInklE CARE is not On, the dryer will stop once the timer reaches the WRInklE CARE mark on the cycle dial. G About the dryer features. 9 Reversing the Door Tools needed: n Standard #2 n Tape-tipped Phillips screwdriver putty knife Open the door and remove the filler plugs opposite the hinges. With the door completely open, remove the bottom screw from each hinge on the dryer face. Insert these screws about half way into the TOP holes, for each hinge, on the opposite side (where you removed the filler plugs). Apply firm pressure to get the screw started in new holes. Loosen top screw from each hinge on the dryer face half way. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it uP and OuT. Rotate the door 180°. Insert it on the opposite side of the opening by moving the door In and DOWn until the top hinge and the bottom hinge are resting on the top screws inserted in step 1. Remove the remaining screws from the side of the opening from which the door was removed. With these screws, secure each hinge at the bottom. Tighten the two top screws of each hinge. Reinsert the plastic plugs on the side from which the door was removed. 4 3 2 1 About reversing the door. GEAppliances.com Machine wash cycle Normal Permanent Press/ wrinkle resistant Gentle/ delicate Hand wash Do not wash Do not wring Water temperature Hot (50°C/120°F) Warm (40°C/105°F) Cold/cool (30°C/85°F) Tumble dry Dry Normal Permanent Press/ wrinkle resistant Gentle/ delicate Do not tumble dry Do not dry (used with do not wash) Heat setting High Medium Low No heat/air Special instructions Line dry/ hang to dry Drip dry Dry flat In the shade Bleach symbols Any bleach (when needed) Only non-chlorine bleach (when needed) Do not bleach WASh lAbElS DRy lAbElS blEACh lAbElS About loading and using the dryer. Always follow the fabric manufacturer’s care label when laundering. Sorting and Loading Hints As a general rule, if clothes are sorted properly for the washer, they are sorted properly for the dryer. Do not add fabric softener sheets once the load has become warm. They may cause fabric softener stains. Bounce® fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in acco...

Herunterladen

Geben Sie zwei Ziffern: