Stimmen - 1, Durchschnittliche Bewertung: 3 ( )

Hersteller: Amana Dateigröße: 129.06 kb Dateiname: a14bcc24-c076-4bb6-98a9-4ddf0768f3b0.pdf Unterrichtssprache:

2. Install a U.L. approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. 3. Thread a U.L. Approved 30 Amp. Power cord, NEMA 10-30 Type SRDT, through the strain relief. 4. Attach the power cord neutral (center wire) conductor to the silver colored center terminal on the terminal block. Tighten the screw securely. 5. Attach the remaining two power cord outer conductors to the outer brass colored terminals on the terminal block. Tighten both screws securely. Warning: Do not make a sharp bend or crimp wiring/conductor at connections. 6. Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten screws securely. 7. Tighten the screws securing the cord restraint firmly against the power cord. 8. Tighten the strain relief nut securely so that the strain relief does not turn. 9. Reinstall the terminal block cover. 19 GDZ22-1 manual 10/22/01 11:45 AM Page 21 English 4-Wire Cord Connections green power cord silver terminal green ground screw green neutral ground wire ground wire terminal block tighten nut to these threads black white nut strain relief mounting bracket power cord red 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a U.L. approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. 3. Remove the green neutral ground wire from the green ground screw located above the terminal block. Typical Conductor Receptacle Typical 4 Conductor Cord black 240V white neutral red 240V green ground 30 AMP NEMA 14-30 TYPE SRDT OR ST 20 GDZ22-1 manual 10/22/01 11:45 AM Page 22 English 4. Thread a U.L. approved 30 Amp power cord, NEMA 14-30 type ST or SRDT through the strain relief. 5. Attach the green power cord ground wire to the cabinet with green ground screw. 6. Attach the white (neutral) power cord conductor from the power cord and the green ground wire from the dryer harness to the silver-colored center terminal on the terminal block. Tighten the screw securely. 7. Attach the red and black power cord conductors to the outer brass-colored terminals on the terminal block. Warning: Do not make a sharp bend or crimp wiring/conductor at connections. 8. Tighten the screws securing the cord restraint firmly against the power cord. 9. Tighten the strain relief nut securely so that the strain relief does not turn. 10. Reinstall the terminal block cover. Caution: Label all wires prior to disconnection, when servicing controls. Wiring errors can cause improper operations and be dangerous. Check unit for proper operation after servicing. Warning: Discard or destroy the carton and plastic bags after the dryer is unpacked. Children should not be allowed to use them to play with. Cartons covered with rugs, bedspreads, or plastic sheets can become an airtight chamber and cause suffocation leading to death. Make all packing materials inaccessible to children. Warning: The instructions in this manual and all other literature included with this dryer can not cover every possible condition and situation that may occur. Good safe practice and caution must be applied when installing, operating and maintaining any appliances. After installing, if you are in doubt, call a certified electrician to install and wire the dryer. 21 GDZ22-1 manual 10/22/01 11:45 AM Page 23 English Limited Warranty Full ONE Year In-Home Warranty For 12 months from the date of original retailpurchase, Haier will repair or replace anypart free of charge including labor that failsdue to a defect in materials or workmanship. Limited Warranty After one year from the original retail purchase date, Haier will provide a part at nocost, as indicated below, to replace said partas a result of a defect in materials or workmanship. Haier is responsible solely for thecost of the part. All other costs such as labor, trip charge, etc are the responsibility of the owner. Second Yea...

Herunterladen

Geben Sie zwei Ziffern: