You can perform nailing operations with less fatigue by doing so. A nail will be bent or the tool can become jammed if you mistakenly nail on top of another nail or strike a knot in the wood. The nail may be thrown and hit someone, or the tool itself can react dangerously. Place the nails with care. I Do not leave the loaded tool or the air compressor under pressure for a long time out in the sun. Be sure that dust, sand, chips and foreign matter will not enter the tool in the place where you le

Failure to maintain sufficient lubrication will cause O-rings to wear quickly. (1) Oiler <2) Pneumatic oil Keep the air hose away from heat (over 60°C, over 140°F), away from chemicals (thinner, strong acids or alkalis). Also, route the hose away from obstacles which it may become dangerously caught on during operation. Hoses must also be directed away from sharp edges and areas which may lead to damage or abrasion to the hose. La SECURITE et la FIABILITE de cet outil ne seront préserves qu

Do not attempt to carve or engrave on the tool. 27. Stop nailing operations immediately if you notice something wrong or out of the ordinary with the tool. 28. Always disconnect the air hose and remove all of the nails: (1) When unattended. (2) Before performing any maintenance or repair. (3) Before cleaning a jam. (4) Before moving the tool to a new location. 29. Perform cleaning and maintenance right after finishing the job. Keep the tool in tip-top condition. Lubricate moving parts to prevent

15 GAUGE (DA) 7jiakita. 2-1/2" finish nailer WELL BA LANCED PNEUMJ 1/4" - 2-1/2" 15 Ga DURABILITY IC 15 GAUGE (DA) FINISH NAILER uge DA Style Finish Nails with a Capacity of 120 Nails se Protects the Wood Surface for a Quality Finish omfortable Operation ring and Installation, Hardwood Floor Installation, e Manufacturing and More FINISHED TO PERFECTION Model AF633 Features & Benefits ■ Aluminum magazine holds 120 15 gauge DA style finish nails (1-1/4" to 2-1/2") ■ Easy loading,angled

Select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing frequency and compressor air output at a compression of 8.5 kgf/cm.G (120 PSIG). Thus, for example, when you drive about 10 nails 3.75 mm x 90 mm (0.148” x 3-1/2”) per minute, a compressor with an air output over 55 l/minute is required. Pressure regulators must be used to limit air pressure to the rated pressure of the tool where air supply pressure exceeds

Operate the tool within the specified air pressure of 4.5 -8.5 kgf/cm.G (65 -120 PSIG) for safety and longer tool life. Do not exceed the recommended max. operating pressure of 8.5 kgf/cm.G (120 PSIG). The toot should not be connected to a source whose pressure potentially exceeds 14.0 kgf/cm.G (200 PSIG). Never use the tool with other than compressed air. If bottled gas (carbon dioxide, oxgen, nitrogen, hydrogen, air, etc.) or combustible gas (hydrogen, propane, acetylene, etc.) is used as a po