Manual setting/advancement should not be done during programme run. q Washing, Soaking Rinsing and Spinning can be seen through the porthole door. q At any moment the position of the knob with respect to its start position shows how far the programme has advanced. q The starting point is just beyond the thick line on the Facia. Switching Off The Machine q The wash ends automatically at the end of each programme at the thick line. q To switch the machine OFF release the START button. q The indica

19-20 Warranty ............................................................21 Notes .................................................................22 Francais ..............................................................23 TABLE OF CONTENTS 137339000A USA 1-800-944-9044 Canada 1-800-265-8352 All about the Use&Care of your Dryer Important Safety Instructions ..............................2-4 Features ...............................................................5 Operating Instructions ......

If washer or dryer is new and has not been installed yet, skip to step 4. 2. If dryer is already installed, disconnect dryer from electrical and gas connections and exhaust venting. 3. If washer is already installed, disconnect washer from electrical connection. Turn off hot and cold water supply and disconnect hot and cold water supply hoses from water supply outlets. Disconnect drain hose from drain pipe. 4. If appliance has plastic feet, screw each foot fl ush to the base. 5. If appliance has

Wipe tub with a nonabrasive household cleanser, then rinse. Shake or brush excess dirt and sand from items before washing. Wash load too wet after spin. Washer is overloaded. Do not overload washer. See Washing Procedures. Load is out of balance. Rearrange load to allow proper spinning. Drain hose is kinked. Straighten drain hose. Water does not enter washer or it enters slowly. Water supply is not adequate in area. Check another faucet in the house. Wait until water supply and pressure increase

Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70. For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. -Do not store or use gasoline or other flammable vapors and liquid in the vicinity of this

If the washer serial number is below XC703, proceed with instructions 10 through 12. 10. In slot number 2, insert a small wire (paper clip) between the locking tab of the red wire terminal and the housing. Note: The locking tab is located in the small rectangular slot below the terminal. DO NOT push down on the contact prongs on the wire terminal. 11. Pull the red wire out of the slot. 12. Insert the red wire into slot number 4 until the terminal clicks into the housing. Gently pull on the wi

For discoloration of an entire load, use phosphate detergent and Rust, brown or yellow nonchlorine bleach. Do not use chlorine bleach because it may intensify discoloration. discoloration LIQUID: Pretreat with a paste of granular detergent and water. PASTE: Scrape residue from fabric. Pretreat Shoe polish with prewash stain remover or nonflammable dry cleaning fluid. Rinse. Rub detergent into dampened area. Wash using bleach safe for fabric. Pretreat or soak in product containing enzymes. Wash u

27” (69 cm) WideLAUNDRY CENTER Washer -Dryer Installation Instructions CENTRO DE LAVANDERIA de 27" (69 cm) de anchoLavadora -Secadora Instrucciones para la instalacion Table Of Contents SUBJECT PAGE Pre-Installation Requirements...............................2 Electrical Requirements..........................................3 Water Supply Requirements ....................................3 Drain Requirements.................................................3 Exhaust System Requirements ...........

Wash using bleach safe for fabric. Pretreat or soak in product containing enzymes. Wash using bleach safe for fabric. TREATMENT TREATMENTTREATMENTTREATMENTTREATMENTTREATMENT Stain Removal Stain RemovalStain RemovalStain RemovalStain RemovalStain Removal 7 Common Washing Problems Common Washing Problems PROBLEM PROBLEMPROBLEMPROBLEMPROBLEMPROBLEM POSSIBLE CAUSES SOLUTIONS SOLUTIONSSOLUTIONSSOLUTIONSSOLUTIONSSOLUTIONSPOSSIBLE CAUSESPOSSIBLE CAUSESPOSSIBLE CAUSESPOSSIBLE CAUSESPOSSIBLE CAUSES PREVE

• A suitable drying temperature, dryness level and options will automatically be indicated for the cycle selected. See the “Dryer Settings Chart” for more details. • To change the drying temperature and dryness level, press the Temp or Dry Level buttons to scroll to the desired settings. • To select or delete an option, press Options; then, while the indicator is blinking, press Select. The indicator will light when the option has been selected. It will no longer be lighted when the option has b