Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Clean the fluff filters The fluff filter consists of two parts. Clean the inner and outer fluff filter after every drying cycle. 1. Open the door. Remove fluff from the door/door area. 2. Pull out the inner and outer fluff filter and open them out. 3. Remove any fluff, rinse both fluff filters under running water and dry thoroughly. 4. Fold the fluff filters closed, put them back together and reinsert into the appliance. 7 6 End of the programme ... Interrupt the programme 1 Open the door or press the Inicio/Pausa (Start/Pause) ..button; the drying cycle is cancelled. 2 Add or remove laundry and close the door. 3 If required, select a new programme and additional functions. Press the Inicio/Pausa (Start/Pause) ..button. The Terminado en/em (Finish in) time is updated after a few minutes. Remove the laundry and switch off the dryer 5 4 Condensation container with filter Fascia panel Two-part fluff filter Air inlet Door tenance instructions, Page 1 Clean fluff filters reduce energy consumption. me e display using the buttons ....C/board Dry Extra, ....C/board Dry, ....Iron Dry duced ironing function can be set up to 120 mins e delay / ....Childlock Spin Speed, ....Adjust drying level, ....low heat signal, button signal, auto power-off and Language panel / Buttons Select the Inicio/Pausa (Start/Pause) ..button Further information can be found on Page 5 5 6 Display panel and buttons ..Display panel Please clean lint filter Clean the fluff filters ..Page 4. Please empty condensate container Empty the condensation container ..Page 4 and/or clean the filter in the condensation container ..Installation and maintenance instructions, Page 3. Heat exchanger is being rinsed Automatic cleanin g of the heat exchanger. Do not empty the c ondensation container while this is displayed. ..Buttons Ajuste secar (Drying Target) Select the dryness level (e.g. C/board Dry) or the drying time (20 mins up to 3 hrs: 30 mins., depending on the model and programme). ..C/board Dry Extra: For laundry with thick, multi-layered parts. ..C/board Dry: For single-layered laundry. ....Iron Dry: The condition of the laundry means it is suitable for ironing (iron clothes in order to avoid creases). Menos ..(Less Ironing) After the pro gramme finishes, the drum moves at regular intervals to prevent creases. Automatic reduced ironing function can be set in 30-minute intervals up to 120 minutes. The standard s etting for each programme is 60 minutes. Terminado en/em (Finish in) When a programme is selected, the anticipated drying time for the maximum load is displayed. While drying, the moisture sensors detect the actual load and correct the programme length. This is sho wn in the display by jumps in the Terminado en/em (Finish in) time. The Terminado en/em (Finish in) time can be delayed in one-hour s teps, up to a maximum of 24 hours. Press the Terminado en/em (Finish in) button repeatedly until the required number of hours is displayed (h=hour). ..Childlock: Activate/Deactivate ..Start programme, press and hold the Terminado en/ em (Finish in) button above the display panel for 5 seconds. ....Menu (Options) ....Spin Speed; ....Adjust drying level; ..low heat ....Spin Speed: The spin speed that was used for the spin in the washing machine ..used exclusively to display the anticipated drying time (Terminado en/em (Finish in) time) more precisely. ....Adjust drying level: The drying result (e.g. C/board Dry) can be increased in three stages (+1 -max. +3); exception: Timer programme....default setting = 0. After one programme has been finely adjusted, the setting is retained for the others. ....low heat: Reduced temperature for delicate fabrics .., e.g. polyacrylic, polyamide or elastane, with a lo nger drying time. Memoria 1/ 2 (Memory 1/2) For saving individual programme settings that are used frequently. Use the programme selector to select the required programme. Press and hold the Memoria 1/2 (Memory 1/2) button for 3 seconds until the required programme has been saved. To select the saved programme, briefly press the Memoria 1/2 (Memory 1/2) button. The programme that is called from Memoria 1/2 (Memory 1/2) is displayed on the display panel. Ajustes base 3s. (Basic Settings 3 sec.) End signal,button signal,auto power-off and Language. Press and simultaneously hold both Ajustes base 3s. (Basic Settings 3 sec.) buttons fo r 3 seconds, in order to access the menu. end signal/button signal: The signal volume level can be selected: off -quiet -medium -loud -very loud. auto power-off: Activate/deactivate by pressin g the Ajustes base 3s. (Basic Settings 3 sec.) buttons . The dryer automatically s witches off, depending on your selection, after 15, 30 or 60 minutes. The setting is active after Menos ..(Less Ironing) or after the programme ends. Language: Select the required language. Information on laundry ... Labelling of fabrics Follow the manufacturer's care information. ....Suitable for tumble drying ..Dry at normal temperature. ....Dry at low t...
Dieses Handbuch ist für folgende Modelle:Waschmaschinen - WT46Y700EE/05 (1.83 mb)