Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
– Check the dryer for transport damage. – The dryer is very heavy. Do not attempt to lift it on your own. – Be careful to avoid sharp edges. – Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage. – Do not set up in a room that is susceptible to frost. Freezing water may cause damage. – If in doubt, have the appliance connected by a specialist. Setting up the dryer – The mains plug must always be accessible. – Ensure that the appliance is placed on a clean, level and firm surface. – Do not obstruct the air inlet on the dryer. – Keep the area around the dryer clean. – Level the dryer using the threaded feet and a spirit level. Never remove the threaded feet! For mains connection, see Safety instructions .. page 13. – Connect to an AC earthed socket. If in doubt have the socket checked by a specialist. – The mains voltage and the voltage shown on the rating plate (.. page 10) must be the same. – The connected load and necessary fuse protection are specified on the rating plate. Converting the installed load Note the fuse protection of the socket (10/16 Amps.). 1. Turn the programme selector to Off. 2. Press and hold the ....(Fine adjust) button. 3. Turn the programme selector to Cottons Cupboard Dry Extra; wait until the recent setting appears in the display: ....=10A or ......=16A. 4. Press the ....(Fine adjust) button to change the settings. 5. Turn the programme selector to Off. Frost protection / Transport Preparation 1. Empty the condensate container .. page 4/11. 2. Select any programme using the programme selector. 3. Press the .. Start/Pause button .. condensation is pumped into the container. 4. Wait several minutes or until the dryer stops, and then empty the condensate container again. 5. Turn the programme selector to Off. 1. Take all accessory parts out of the drum. The drum must be empty. Make sure that the air inlet remains unobstructed Clean and level Do not install the dryer behind a door or sliding door which could prevent or obstruct the dryer door from opening. This will prevent children from locking themselves in and risking their lives. 2. 3. Do not operate the dryer if there is a risk of frost. 10 Optional accessories (order from the after-sales service using the order number, depending on model) Connection fittings for condensation outlet The condensation is conveyed directly via a hose. Washer-dryer stack connection set The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. This connection set must always be used to secure the dryer to the washing machine. WZ 20400: with pull-out worktop. Platform For easier loading and unloading. The basket contained in the drawer can be used to carry the laundry. Technical data Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable) Weight approx. 45 kg Max. capacity 8 kg Condensation container 4.2 l Connection voltage 220-240 V Connected load 2100-2800 W Fuse protection 10 A / 16 A Ambient temperature 5-35°C Product number Production number Inside of door The rating plate can be found on the back of the dryer. ..Drum interior light (depending on model): The drum lights up after the door is opened and after the programme starts, and switches off automatically. WZ 20160 WZ 20410 WZ 20500 Consumption rates (The value on the label is achieved at the maximum heat setting.) Fabrics/programmes Residual moisture in the fabrics after spinning Drying time** Energy consumption** ....Cottons 8 kg 10 A 16 A 10 A 16 A ....Cupboard Dry* 1400 U/min (50%) 140 min 108 min 3.74 kWh 3.74 kWh 1000 U/min (60%) 158 min 126 min 4.49 kWh 4.49 kWh 800 U/min (70%) 176 min 144 min 5.17 kWh 5.17 kWh ....Iron Dry* 1400 U/min (50%) 116 min 86 min 2.24 kWh 2.24 kWh 1000 U/min (60%) 135 min 103 min 3.44 kWh 3.44 kWh 800 U/min (70%) 153 min 121 min 3.86 kWh 3.86 kWh ....Easy-Care 3.5 kg ....Cupboard Dry* 800 U/min (40%) 52 min 46 min 1.42 kWh 1.42 kWh 600 U/min (50%) 65 min 56 min 1.74 kWh 1.74 kWh * Programme setting for testing in accordance with applicable standard DIN EN61121. ** The values may differ from those specified, depending on the type of fabric, composition of laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded. 10Optional accessories (order from the after-sales service using the order number, depending on model) Connection fittings for condensation outlet The condensation is conveyed directly via a hose. Washer-dryer stack connection set The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. This connection set must always be used to secure the dryer to the washing machine. WZ 20400: with pull-out worktop. Platform For easier loading and unloading. The basket contained in the drawer can be used to carry the laundry. Technical data Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable) Weight approx. 45 kg Max. capacity 8 kg Condensation container 4.2 l Connection voltage 220-240 V Connected load 2100-2800...