Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Fabrics must be suitable for tumble drying. After drying.. . .... iron laundry .. lightly iron laundry ....do not iron laundry ..mangle laundry PROGRAMMES TEXTILE TYPE AND INFORMATION max. 7 kg Hard- wearing fabrics, boil- resistant fabrics made of cotton or linen. * * .. F Cottons max. 3.5 kg Non- iron laundry made of synthetic fibres and blended fabric, easy-care cotton. * * .... Synthetics .. Iron Dry .............. Fabrics suitable for ironing ( iron fabrics in order to avoid creasing) . Fabrics with membrane coating, water- repellent fabrics, functional clothing, fleece fabrics ( dry jackets/ trousers with max. 1.5 kg .... Sportswear removable internal lining separately). Laundry made of synthetic fibres, cotton or blended fabrics (for example) that needs to be dried quickly. The values may max. 2 kg A Super 40’ differ from the those specified depending on the type of fabric, mixture of laundry to be dried, residual moisture in thefabric and loading capacity. Pre- dried, multi- layered, sensitive fabrics made of acrylic fibres, or separate small items of laundry. max. 3 kg Timed progr. 20 min Also for subsequent drying. * for ...... Cottons and .... Synthetics programmes only * *Dryness levels can be selected individually ...... : Very Dry, .. . Cupboard Dry and .. Iron Dry ( depending on the model) . Degree of dryness can be finely adjusted; multi-layered textiles require a longer drying time than single- layered items of clothing. Recommendation: Dry separately. 8 Installation – Delivery specification: dryer, instructions for installation and use, woollens basket (depending on model). – Check dryer for transport damage. – The dryer is very heavy. Do not attempt to lift it on your own. – Be careful to avoid sharp edges. – Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off. – Do not set up in a room that is susceptible to frost. Freezing water may cause damage. – If in doubt, have the appliance connected by an expert. Setting up the dryer – The appliance plug must always be accessible. – Ensure that the appliance is installed on a clean, level and solid surface. – Keep the cooling grille at the front of the dryer unobstructed. – Keep the area around the dryer clean. – Make the dryer level using the threaded feet and a spirit level. Do not remove the threaded feet under any circumstances. Mains connection see safety instructions ..Page 11. – Connect to an AC earthed socket. If in doubt have the socket checked by an expert. – The mains voltage and the voltage shown on the rating plate (..Page 9) must correspond. – The connected load and necessary fuse protection are specified on the rating plate. Converting the installed load Note the fuse protection of the socket. 10/16 Amps Frost protection / Transport Preparation 1. Empty the condensation container ..page 4. 2. Select any programme using the programme selector. 3. Press the ..Start/Stop button ..condensation is pumped into the container. 4. Wait 5 min., and then empty the condensation container again. 5. Turn the programme selector to 0 (Off). 1. Take all accessory parts out of the drum. The drum must be empty. Make sure that the air inlet remains unobstructed Clean and level 2. 3. turn to 0 (Off) Press and hold selection then turn 3 x to the right turn to 0 (Off) Set amperage 1 x to the right Feedback (depending on model): off flashes 10 A 16 A .... Do not operate the dryer if there is a danger of frost. Do not set up the dryer behind a door or sliding door as this may obstruct or prevent the dryer door from opening. This will prevent a potentially fatal danger to children from locking themselves in. 9 Technical data ..Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable) Weight approximately 45 kg Max. capacity 7 kg Condensation container 4.2 l Connection voltage Connected load Fuse protection see appliance rating plate Ambient temperature Product number/ Production number You can find the rating plate on the back of the dryer. ..Drum interior light (depending on model) (bulb E14, 25 W) The drum lights up after the door is opened or closed, and after the programme starts, and switches off automatically. Changing the bulb ..page 10. Consumption rates (The value on the label is achieved at the maximum heat setting.) Fabrics/programmes Residual moisture in the fabrics after spinning Drying time** Energy consumption** ....Cottons 7 kg 10 A 16 A 10 A 16 A ... Cupboard Dry* 1400 rpm (50%) 112 min 98 min 3.54 kWh 3.54 kWh 1000 rpm (60%) 131 min 115 min 4.13 kWh 4.13 kWh 800 rpm (70%) 150 min 133 min 4.72 kWh 4.72 kWh ..Iron Dry* 1400 rpm (50%) 93 min 69 min 2.55 kWh 2.55 kWh 1000 rpm (60%) 111 min 82 min 3.22 kWh 3.22 kWh 800 rpm (70%) 130 min 94 min 3.90 kWh 3.90 kWh ....Synthetics 3.5 kg ... Cupboard Dry* 800 rpm (40%) 48 min 42 min 1.35 kWh 1.35 kWh 600 rpm (50%) 60 min 51 min 1.65 kWh 1.65 kWh * Programme setting for testing in accordance with applicable standard EN61121. ** The values may differ from those spec...