Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Moisture sensors measure the moisture level of the laundry. After sustained, repeated operation, a fine layer of limescale may form on the moisture sensors. 1. Open the door. 2. Clean the moisture sensors using a slightly damp sponge with a rough surface. Do not use steel wool or abrasive materials. 56 Programme overview see also page 5 After drying: T-shirt Shirts Trousers Skirts/dresses Sports wear Wor k clothin g Anoraks Terry to welling/ ba th robe Underwear Socks Bed linen Table l inen Terry to wels Tea towels/ h an d towels ....iron gentle iron ....do not iron....mangle ....Cottons max. 6 kg Suitable for cottons, coloureds and linens.Iron Dry .............. .. * * .. * .. * .. * .. * .. * .. * Cupboard Dry ........................ * .. * .. * .. * .. * Very Dry ........................ * .. * .. * .. * .. * .. * ....Easy-Care max. 3 kg For non-iron laundry made of synthetic fibres and mixed fabric, cotton.Iron Dry ................ * .. * .. * .. * .. * .. * Cupboard Dry ........................ * .. * .. Timed Programmes max. 3 kg For pre-dried, quilted, delicate fabrics made of acrylic, or separate small items of laundry.Warm 60 min For quilted, delicate fabrics made of acrylic or cottonWarm 40 minWarm 20 min For pre-dried, quilted, delicate fabrics made of acrylic, or separate small items of laundry.Also for subsequent drying.Cold 20 min 7 Installation . Scope of delivery: dryer, instruction manual and installation instructions. . Check dryer for transport damage. . The dryer is very heavy. Do not lift without assistance. . Be careful to avoid sharp edges. . Do not lift the dryer by protruding parts (e.g. the door) -risk of breakage. . Do not install in a room where there is a risk of freezing. Freezing water can cause damage. . If in doubt, have the appliance connected by a specialist. 1. Setting up the dryer . The mains plug must always be accessible. . Ensure that the appliance is installed on a clean, level and firm surface. . Install the exhaust air duct a Installation instructions for exhaust air duct. . Keep the area around the dryer clean. . Level the dryer using the front threaded feet. . Do not unscrew the threaded feet more than 20 mm. On no account remove the threaded feet. Remove all accessories from the drum. The drum must be empty. Clean and level Do not install the dryer behind a door or sliding door which could prevent or obstruct the dryer door from opening. This will prevent children from locking themselves in and risking their lives. 2. Mains connection For safety instructions, a page 11. . Connect to an AC earthed socket. If in doubt have the socket checked by a specialist. . The mains voltage and the voltage shown on the rating plate (a page 9) must be the same. . The connected load and necessary fuse protection are specified on the rating plate. 8 0310 / 9000521274 Robert Bosch Hausgerate GmbHCarl-Wery-Str. 34 WTA84100GB *521274 * 81739 Munchen, Deutschland 9Technical data ..Dimensions (DxWxH) 60 x 60 x 85 cm Weight approximately 35 kg Max. capacity 6 kg Ambient temperature 5 -35 °C Connection voltage 220 -240 V Connected load 2200 W Fuse protection 10 A Product number ..Rating plate or inside of the door Production number You can find the rating plate on the back of the dryer. ..Consumption rates These are guide values determined under standard conditions. Deviations of up to 10% are possible. Spin speed rpm (residual moisture) Drying time** in min incl. 8 min cooling time Energy consumption** in kWh Cottons 6 kg Cupboard Dry* 1400 (approx. 50 %) 100 3.00 1000 (approx. 60 %) 120 3.38 800 (approx. 70 %) 140 4.00 Iron Dry* 1400 (approx. 50 %) 78 2.00 1000 (approx. 60 %) 93 2.00 800 (approx. 70 %) 108 3.00 Easy-Care 3 kg Cupboard Dry* 800 (approx. 40 %) 44 1.00 600 (approx. 50 %) 55 1.00 *Test programmes according to DIN EN 61121. **The values may diverge from those specified depending on overvoltage and undervoltage, fabric type, composition of the laundry to be dried, residual moisture in the fabric and the amount of the load. Optional accessories (order from the after-sales service using the order number) Exhaust air duct set (according to model) The exhaust air is extracted via a hose. Washer-dryer stack connection set The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. The dryer must be fastened to the washing machine using this connection set. If the worktop of the washing machine is less than 544 mm deep, please consult the after-sales service or your specialist retailer. Built-under installation Instead of the appliance covering plate, you must have a metal cover fitted by a specialist. Platform For improved loading and unloading. The basket located in the drawer can be used for carrying laundry. WTZ 1130 WTZ 11311 WTZ 10295 WMZ 20460 9Technical data ..Dimensions (DxWxH) 60 x 60 x 85 cm Weight approximately 35 kg Max. capacity 6 kg Ambient temperature 5 -35 °C Connection voltage 220 -240 V Connected load 2200 W Fuse p...
Dieses Handbuch ist für folgende Modelle:Waschmaschinen - WTA84100GB/03 (1.62 mb)