Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Let it cool. Do not reach into the drum if it is still rotating. Do not open the washing machine door if water can be seen through the glass. 1. Turn the programme selector to Fran (Off) and disconnect the mains plug. 2. Drain the detergent solution ....page 10. 3. Pull the emergency release downwards with a tool and release. The washing machine door can then be opened. Information on the display panel depending on model .. flashes Close the washing machine door properly; laundry may be caught. ..: ...., ..: .... Turn on the (cold water) tap fully, supply hose kinked or trapped; Clean the filter ....page 10, water pressure too low. ..: .... – Detergent solution pump blocked; Clean the detergent solution pump ....page 10. – Drainage hose / waste pipe blocked; Clean the drainage hose at the siphon ....page 10. – Heavy foam build-up ....page 11, status indicator .. flashes. ..: .... Water in the base tub, appliance leaking. Call customer services! ..: .... – Open the (hot water) tap fully. – Inlet hose kinked/trapped. – Water pressure too low. Clean the filter ....page 10. – Hot water hose not connected; appliance will operate using cold water only. Ignore information, only for first wash cycle. .. Childproof lock activated: to deactivate .. page 5. – Risk of electric shock! Disconnect the mains plug. – Risk of explosion! Do not use solvents. 10 Maintenance Detergent solution pump Turn the programme selector to Fran (Off) and disconnect the mains plug. 1. Using a screwdriver or the insert for liquid detergent (depending on model), open and remove the service flap. 2. Remove the folding gutter and place a large enough container underneath. 3. For models with a drainage hose: Remove the drainage hose from the retainer and pull it from the housing. Remove the sealing cap, allow the detergent solution to flow out into the container. Replace the sealing cap and place the drainage hose in the retainer. 3* For models without a drainage hose: Carefully unscrew the pump cover 180° or until the detergent solution begins to flow out on the folding gutter. When the container is full, close the pump cover and empty the container. Repeat the above steps until all the detergent solution has completely drained out. 4. Carefully unscrew the pump cover (there may be residual water). 5. Clean the interior, pump cover thread and pump housing (the impeller in the detergent solution pump must rotate). 6. Replace the pump cover and screw it tightly. 7. Return the drainage hose (depending on model) and the folding gutter to their start position. 8. Place the service flap back on and close. To prevent unused detergent from flowing straight into the drain during the next wash: Pour 2 litres of water into compartment II and then start the Urpumpning (Empty) programme. Drainage hose at the siphon Turn the programme selector to Fran (Off) and disconnect the mains plug. 1. Loosen the hose clamp, carefully remove the drainage hose (residual water). 2. Clean the drainage hose and siphon connecting piece. 3. Reattach the drainage hose and secure the connection with the hose clamp. Filter in the water supply Risk of electric shock! Do not immerse the Aqua-Stop safety device in water (contains an electric valve). Reduce the water pressure in the supply hose: 1. Turn off the tap. 2. Select any programme (except Skoljning/Centrifugering (Rinse/Spin) // Urpumpning (Empty)). 3. Choose .. (Start/Reload). Let the programme run for approximately 40 seconds. 4. Turn the programme selector to Fran (Off). Disconnect the mains plug. Clean the filter: 5. Disconnect the hose from the tap. Clean the filter using a small brush. and/or for Standard and Aqua-Secure models: Remove the hose on the rear of the appliance. Remove the filter with pliers and clean. 6. Connect the hose and check for leaks. – Risk of burning! Allow the detergent solution to cool. – Turn off the tap. What to do if... . Water is leaking out – Attach/replac– Tighten the sce the drainage hose correctly. rew connection of the supply hose. . No water supply. Detergent not dispensed. – $ (Start/Rel– Tap not turned – Filter blocked? – Supply hose koad) not selected? on? Clean the filter ....page 10. inked or trapped? . The appliance door will not open. – Safety functio– (without fin– Can be opene– Door locked amachine and n active. Programme stopped? ....page 4. al spin) selected? ....page 3, 4. d by emergency release only? ....page 9. fter the washing machine is switched off: Switch on the washing wait for 5 seconds. . The selected programme does not start. – $ (Start/Rel– Washing mach– Childproof locoad)..or .. (Ready in) time selected? ine door closed? k active? Deactivate ....page 5. . Detergent solution is not drained. – (without fin– Clean the dete– Clean the wasal spin) selected? ....page 3, 4. rgent solution pump ....page 10. te pipe and/or drainage hose. . No water can be seen in the drum. – Not a fault. Water remains inside below the visible area. . Spin result not satisfactory. Laund...
Dieses Handbuch ist für folgende Modelle:Waschmaschinen - WAQ28462SN/01 (2.47 mb)