Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Disconnect the mains plug. . Sever the mains cable and discard along with the plug. . Destroy the lock on the washing machine door. This will prevent children from locking themselves in and risking their lives. Danger of suffocation . Keep packaging, film and packaging parts out of the reach of children. Risk of poisoning . Keep detergents and care products out of the reach of children. Risk of explosion . Items of laundry pretreated with cleaning agents containing solvents, e.g. stain remover/cleaning solvent may cause an explosion after being loaded into the washing machine. Rinse items of laundry thoroughly by hand beforehand. Risk of injury . The washing machine door can become very hot. . Be careful when draining hot detergent solution. . Do not climb onto the washing machine. . Do not lean on the open washing machine door. . Do not reach into the drum if it is still rotating. . Be careful when opening the detergent drawer while the machine is in operation. Consumption values Programme Additional function Load Electricity consumption** Water** Programme duration** ....Cottons 40 °C 7 kg 0.69 kWh 60 l 2:36 h ....Cottons 60 °C 7 kg 1.33 kWh 60 l 2:39 h ....Cottons 60 °C ....EcoPerfect* 7 kg 1.05 kWh 47 l 3:08 h ....Cottons 90 °C 7 kg 2.00 kWh 64 l 2:47 h ....Easy care 40 °C 3 kg 0.55 kWh 55 l 1:37 h ....Mix 40 °C 3 kg 0.48 kWh 32 l 1:03 h ..../ Wool cold 2 kg 0.10 kWh 39 l 0:40 h ..../ Wool 30 °C 2 kg 0.19 kWh 39 l 0:40 h * Programme setting with maximum spin speed for testing according to or in accordance with IEC 60 456. ** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional functions. 9 Care Before washing for the first time Do not load any laundry into the machine. Turn on the tap. Add the following to compartment II: . approx. 1 litre water . detergent (dosage according to the manufacturer's instructions for light soiling and the appropriate degree of water hardness) Set the programme selector to .. Easy care 60 °C and select .. Start/Pause. At the end of the programme, turn the programme selector to Off. Machine housing, control panel . Wipe with a soft, damp cloth. . Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners). . Remove detergent and cleaning agent residue immediately. . Do not clean with a jet of water. Cleaning the detergent drawer and housing... ... if it contains detergent or fabric softener residues. 1. Pull the drawer out, press down the insert and fully remove the drawer from the housing. 2. To remove the insert: press the insert upwards from below with your finger. 3. Clean the detergent dispenser tray and insert with water and a brush and dry it. Also remove any detergent or fabric softener residues in the housing. 4. Attach the insert and engage (connect the cylinder to the guide pin). 5. Push in the detergent drawer. Leave the detergent drawer open so that any residual water can evaporate. Washing drum and rubber seal Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so that the drum can dry out. Rust stains - use chlorine-free cleaning agent, not steel wool. Descaling Ensure there is no laundry in the machine Descale the appliance according to the descaler manufacturer's instructions. This should not be necessary if the correct dosage of detergent is used. Information on the indicator lights model-dependent A signal sounds and indicator lights for the spin speed flash: ¤ ¤ ¤ ¤ ¤ Close the washing machine door properly; laundry may be caught. ¤ ¤ ¤ ¤ ¤ Detergent solution pump blocked; Clean the detergent solution pump .. page 10. Drainage hose/waste pipe blocked; Clean the drainage hose at the siphon .. page 10. ¤ ¤ ¤ ¤ ¤ Open the tap completely, supply hose kinked or trapped; Clean the filter .. page 10, Water pressure too low. ¤ ¤ ¤ ¤ ¤ Motor fault. Call the after- sales service. ¤ ¤ ¤ ¤ ¤ Water in the base tub, appliance leaking. Call the after-sales service. . Risk of electric shock. Disconnect the mains plug. . Risk of explosion. No solvents. 10 Maintenance Detergent solution pump Turn the programme selector to Off and disconnect the mains plug. 1. Open and remove the service flap. 2. For models with a drainage hose: Remove the drainage hose from the retainer and pull it from the housing. Remove the container. Remove the sealing cap, allow the detergent solution to flow out. Replace the sealing cap and place the drainage hose in the retainer. 2* For models without a drainage hose: Carefully unscrew the pump cover until the detergent solution begins to flow out. When the service flap is half full, close the pump cover and empty the service flap. Repeat the above steps until all the detergent solution has completely drained out. 3. Carefully unscrew the pump cover (residual water). 4. Clean the interior, pump cover ...