Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Samsung Dateigröße: 941.06 kb Dateiname: Unterrichtssprache:

(WITH PUMP) 70~80cm 1 WT80J7-02206A_EN.indd 1 2006-02-17 .AEA 2:43:16 DESCRIPTION OF PARTS SPIN DRYER LID When you open this lid while the spin basket is spinning, the spinning will be stopped by brake system. INNER LID POWER CORD DRAIN HOSE The plug’s shape may (WITH PUMP) not correspond with this drawing. SPIN DRYER BASKET LINT FILTER WASH TUB WASH TUB LID Be sure to keep the lid closed during washing and spinning. WATER DRAIN HOSE (WITHOUT PUMP) PULSATOR DRAIN FILTER (WITH PUMP) CONTROL PANEL 1. WASH SELECTOR 4. AIR TURBO SPIN TIMER This is used to select wash action. This is used to set the spin time, 1-10 minutes. 2. WASH TIMER 5. WATER SELECTOR This is used to set the wash time, 1-15 minutes. During washing, WATER SELECTOR KNOB should 3. CYCLE SELECTOR be selected to wash. During spin rinsing, WATER This is used to select the Washing / Rinsing or SELECTOR KNOB should be selected to spin. draining. 1 2 5 3 4 2 WT80J7-02206A_EN.indd 2 2006-02-17 .AEA 2:43:17 INSTALLATION ENVIRONMENT Leave some space Space at last 15cm between the washer and the wall. Place the washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2°) Never install the washer near water. Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard. Avoid direct sunlight or heating devices. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers,etc. Do not place under direct sunlight. CLEANING THE MACHINE CLENING THE LINT FILTER If the dregs are filled up in the lint filter after finishing the wash, push down(1) and pull it out(2) as shown in figure. Remove the collected lint and rinse the filter net. Lint Filter CLEANING THE WASH TUB HOW TO CLEAN THE FILTER (In case drain pump) 1. Place a rag under the washer filter not to wet the floor. 2. Rotate the filter counterclockwise and pull out the filter. 3. Remove dirts and rotate the filter clockwise until it locks in position. Remark : Should be cleaned Filter at least 1 time a week. Filter Close Rag Open CONNECTING THE DRAIN HOSE Insert the drain hose(a) and push it tighly to be connected as arrow direction. (WITHOUT PUMP) Install the drain hose about 70~80cm above the ground for pump model. 70~80cm OVERFLOW FILTER Pull the upper side of the overflow filter with two fingers into the hole ‘A’ in the direction of arrow as shown in the figure. Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged. 3 WT80J7-02206A_EN.indd 3 2006-02-17 .AEA 2:43:19 4 WASHING PROCEDURE TO WASH 1. Before starting washing, check the following; - Connect the water supply hose and open the water tap. - Connect the power cord to the power supply outlet. - Lay the dr...

Herunterladen

Geben Sie zwei Ziffern: