Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Press the button again to restart the programme. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. You can nowselect a new programme. Opening the door after the programme hasstarted First set the machine to pause by pressing the button 6. After some minutes, the door can be opened. If the machine is already heating, that thewater level is above the bottom edge of thedoor, the door cannot be opened. If you cannot open the door but you need toopen it you have to switch the machine off byturning the selector dial to «O». After a few minutes the door can be opened (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then press the button 6. At the end of the programme The machine stops automatically. The pilot light of button 6 and the phase lights A and B go off, while the phase light C illuminates. The door can be opened. If at the end of a programme there is water in the tub, to empty out the water follow the following instructions: . turn the programme selector dial to «O» . select the «Drain» or «Spin» programme . reduce the spin speed if needed, by meansof the relevant button . press button 6 At the end of the cycle, turn the programmeselector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formationof mildew and unpleasant smells. Care and cleaning IMPORTANT! You must DISCONNECT the appliance fromthe electricity supply, before you can carry outany cleaning or maintenance work. Descaling The water we use normally contains lime. It isa good idea to periodically use a watersoftening powder in the machine. Do thisseparately from any laundry washing, andaccording to the softening powdermanufacturer's instructions. This will help toprevent the formation of lime deposits. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: . The drum should be empty of laundry. . Select the hottest cotton wash programme. . Use a normal measure of detergent, must bea powder with biological properties. External cleaning Clean the exterior cabinet of the appliance withsoap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenserdrawer should be cleaned regularly. To aid cleaning, the top part of the additivecompartment should be removed. Remove the drawer by pressing the catchdownwards and by pulling it out. Flush it outunder a tap, to remove any traces ofaccumulated powder. Cleaning the drawer recess Having removed thedrawer, use a small brush to clean the recess, ensuring thatall washing powderresidue is removed from the upper andlower part of the recess. Replace the drawer and run the rinseprogramme without any clothes in the drum. Cleaning the pump The pump should be inspected if . the machine does not empty and/or spin . the machine makes an unusual noise duringdraining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: . Disconnect the appliance. . If necessary wait until the water has cooleddown. . Open the pumpdoor. . Place a container close to the pump tocollect any spillage. . Pull out the emergency emptyinghose, place it in the container and remove its cap. . When no more water comes out, unscrew the pump cover and remove it. Always keep arag nearby to dry up spillage of water whenremoving the cover. . Remove any objects from the pump impellerby rotating it. . Put the cap back on the emergency emptyinghose and place the latter back in its seat. . Screw the pumpcover fully in. . Close the pumpdoor. IMPORTANT! When the appliance is in use and dependingon the programme selected there can be hotwater in the pump. Never remove the pump cover during a washcycle, always wait until the appliance hasfinished the cycle, and is empty. Whenreplacing the cover, ensure it is securelyretightened so as to stop leaks and youngchildren being able to remove it. Cleaning the water inlet filter If your water is very hard or contains traces oflime deposit, the water inlet filter may becomeclogged. It is therefore a good idea to clean itfrom time to time. Turn off the water tap. Unscrew the water inlet hose. Clean the filter using a hardbristle brush. Tighten up the inlethose. The dangers of freezing If the machine is exposed to temperaturesbelow 0°C, certain precautions should be taken. . Turn off the water tap. . Unscrew the inlet hose. . Place the end of the emergency emptyinghose and that of the inlet hose in a bowl placed on the floor and let water drain out. . Screw the water inlet hose back on and reposition the emergency emptying hoseafter having put the cap on again. . When you intend ...
Dieses Handbuch ist für folgende Modelle:Waschmaschinen - AW 1402 W (752.33 kb)