Stimmen - 4, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
If the fuse cover is lost, the plug must not be used until a replacement is obtained. Replacement fuse covers: If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot. Removing the plug: If your appliance has a non-rewireable moulded plug and you should wish to re-route the mains cable through partitions, units etc., please ensure that either: the plug is replaced by a fused 13 ampere rewearable plug bearing the BSI mark of approval. or: the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance. Disposing of the plug: Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug: Important: the wires in the mains lead are coloured in accordance with the following code: Green S Yellow Earth Blue Neutral Brown Live GB 3 GB As the colours of the wires in the lead may not correspond with the coloured markings identifyng the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or -i- or coloured Green or Green & Yellow. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt the electrical supply to your machine, consult a qualified electrician before use. How to connect an alternative plug: The wires in this mains lead are coloured in accordance with the following code: BLUE NEUTRAL (N) BROWN LIVE (L) GREEN & YELLOW EARTH (E) Disposing of the appliance: When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above. The first wash cycle Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, setting the A programme without a pre-wash cycle. ! The washing machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms. ! When the washing machine is installed, the mains socket must be within easy reach. ! Do not use extensions or multiple sockets. ! The power supply cable must never be bent or dangerously compressed. ! The power supply cable must only be replaced by an authorised serviceman. Warning! The company denies all liability if and when these norms are not respected. 4 ■ Hotpoint Technical details Model HVF 344 59.5 cm wide Dimensions 85 cm high 52.5 cm deep Capacity from 1 to 6 kg Electric please refer to the technical data connections plate fixed to the machine Water connections maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.5 bar) drum capacity 46 litres Spin speed up to 1400 rpm Control programmes according to EN 60456 programme C, temperature 60°C; run with a load of 6 kg. directive This appliance is compliant with the a following European Community Directives: - 73/23/CEE of 19/02/73 (Low Voltage] and subsequent amendments - 89/336/CEE of 03/05/89 (Electromagnetic Compatibility] and subsequent amendments - 2002/96/CE 5 Washing machine description Control panel START/STOP button © START/RESET button TIMER Detergent dispenser to add detergent and fabric softener (see page 10). FUNCTION buttons to select the functions available. The button corresponding to the function selected will remain on. SPIN VARIATION button to adjust the spin speed or exclude it altogether (see page 9). TEMPERATURE VARIATION button to adjust the wash temperature (see page 9). DELAY TIMER button to delay the start of the set programme for a maximum period of 24 hours (see page 9). CHILD LOCK key. To lock all the keys on the washing machine during operation or during Stand-by mode. Display to programme the washing machine and follow the wash cycle progress (see opposite page). START/STOP button to turn the washing machine on and off (see page 8). START/RESET button to start the programmes or cancel any incorrect settings (see page 8). Control knob to select the wash programmes. The retractable control knob: press the centre of the knob for it to pop out. The knob stays still during the cycle. Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by continuously rotating the drum at a speed which is slightly faster than the normal washing speed. When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a low...